Understand the Relationship Between the Fabrics in Chassis Management Groups and Chassis Backup Lead POWEREDGE-MX-MODULAR-DEPLOY Practice Questions (Page 2)

Questions 6–10

1. 6application · medium

   A company is planning a maintenance window for their primary chassis lead in a CMG. The administrator wants to ensure that the backup lead can take over fabric management without any interruption to the network traffic of the servers in the chassis. What should the administrator do before starting the maintenance?

   • AManually export the fabric configuration from the primary lead and store it in a safe location.
   • BReconfigure the IOMs in the backup chassis to match the primary chassis fabric settings.
   • CShut down all servers in the chassis to prevent any network disruption during the failover.
   • DVerify that the backup lead chassis is powered on and has a synchronized fabric configuration.
   Reveal Solution Discussion Select an answer first
2. 7foundation · easy

   How does the chassis backup lead maintain fabric configuration within a CMG?

   • AIt only stores the configuration when a failover event occurs.
   • BIt does not store fabric configuration; it only manages compute resources.
   • CIt independently creates its own fabric configuration that is used if the lead fails.
   • DIt periodically receives and stores a copy of the fabric configuration from the chassis management lead.
   Reveal Solution Discussion Select an answer first
4. 8expert · hard

   A CMG has two chassis, Chassis A (primary lead) and Chassis B (backup lead). The administrator wants to ensure that if Chassis A fails, the fabric management is taken over by Chassis B with minimal disruption. What is the most important factor to verify?

   • AChassis B has the same firmware version as Chassis A.
   • BChassis B has the same number of IOMs as Chassis A.
   • CChassis B is physically located in the same rack as Chassis A.
   • DChassis B has a synchronized fabric configuration and is reachable on the management network.
   Reveal Solution Discussion Select an answer first
5. 9application · medium

   An administrator is monitoring a CMG and notices that the backup lead has taken over as the primary lead. What is the most likely reason for this change?

   • AThe original primary lead experienced a failure and is no longer available.
   • BThe backup lead has a higher priority than the primary lead.
   • CThe backup lead was rebooted and automatically became the primary lead.
   • DThe administrator manually changed the lead role in the CMG settings.
   Reveal Solution Discussion Select an answer first
6. 10expert · medium

   A CMG has two chassis, Chassis A (primary lead) and Chassis B (backup lead). The administrator needs to replace the IOMs in Chassis A. The replacement IOMs are new and have no configuration. What will happen to the fabric configuration for Chassis A after the IOMs are installed?

   • AThe new IOMs will use a default configuration that is not part of the CMG.
   • BThe backup lead will provide the configuration to the new IOMs.
   • CThe CMG will automatically apply the fabric configuration to the new IOMs from the primary lead.
   • DThe new IOMs will remain unconfigured until the administrator manually applies the configuration.
   Reveal Solution Discussion Select an answer first