Configure Link Aggregation CCA-APPDS-GATEWAY Practice Questions (Page 4)

Questions 16–20

1. 16application · medium

   A Citrix ADC has a LAG configured with LACP. The administrator notices that only one of the two interfaces is active; the other shows as 'not ready' in the LAG status. The switch is configured for LACP active on both ports. What is the most likely cause?

   • AThe second interface on the ADC is configured with a different speed or duplex setting than the switch port.
   • BThe switch ports are in different VLANs.
   • CThe LAG is configured as static instead of LACP.
   • DThe ADC interface is administratively down.
   Reveal Solution Discussion Select an answer first
2. 17application · medium

   A Citrix ADC is being deployed as a gateway. The network team wants to increase the bandwidth between the ADC and the core switch without purchasing new hardware. The switch has two free 1 Gbps ports. Which solution should be implemented?

   • ACreate a LAG with the two ports and add it to the ADC.
   • BUse a single 10 Gbps port on the switch and connect it to the ADC.
   • CEnable port mirroring on the switch to combine the two ports.
   • DConfigure the two ports as separate VLANs and use a routing protocol.
   Reveal Solution Discussion Select an answer first
4. 18foundation · easy

   Which benefit does link aggregation provide in addition to increased bandwidth?

   • AGuaranteed packet ordering across all links
   • BRedundancy by allowing traffic to continue if one physical link fails
   • CIncreased security by isolating traffic on separate links
   • DSimplified IP addressing by using a single IP address for all interfaces
   Reveal Solution Discussion Select an answer first
5. 19application · medium

   An administrator has created a link aggregation group (LAG) on a Citrix ADC and added two interfaces. After committing the configuration, the administrator wants to confirm that both interfaces are active and passing traffic. Which command should the administrator use?

   • Ashow interface
   • Bshow vlan
   • Cshow lag
   • Dshow lacp
   Reveal Solution Discussion Select an answer first
6. 20foundation · easy

   What is a characteristic of static link aggregation on a Citrix ADC?

   • AIt provides faster failover than LACP because no negotiation is needed
   • BIt uses the Link Aggregation Control Protocol to automatically negotiate the bundle
   • CIt allows the switch to automatically detect and add interfaces to the bundle
   • DIt requires manual configuration on both the ADC and the switch, with no negotiation protocol
   Reveal Solution Discussion Select an answer first