Configure Link Aggregation CCA-APPDS-GATEWAY Practice Questions (Page 1)

Questions 1–5

1. 1foundation · easy

   What is the first step when configuring link aggregation on a Citrix ADC?

   • ACreate a link aggregation group (LA channel) and assign a name
   • BAdd physical interfaces to the aggregation group before creating it
   • CAssign an IP address to the aggregation group
   • DConfigure the switch to use the same aggregation mode as the ADC
   Reveal Solution Discussion Select an answer first
2. 2foundation · easy

   When troubleshooting a link aggregation group that is not passing traffic, what is the first thing to check?

   • AWhether the LA channel has an IP address assigned
   • BWhether all member interfaces are UP and the LA channel is UP
   • CWhether the switch has the correct VLAN configuration
   • DWhether the ADC has enough CPU to handle the traffic
   Reveal Solution Discussion Select an answer first
4. 3foundation · easy

   Which command displays the status of link aggregation groups on a Citrix ADC?

   • Ashow la channel
   • Bstat la
   • Cshow interface
   • Dshow link aggregation
   Reveal Solution Discussion Select an answer first
5. 4expert · hard

   An administrator is configuring link aggregation on a Citrix ADC. The switch is a legacy model that does not support LACP but does support static trunking. The administrator wants to ensure that if one link fails, the remaining link continues to carry traffic. What should the administrator do?

   • AUse two separate interfaces with different IP addresses and rely on routing protocols for failover.
   • BConfigure a single interface with a higher speed and disable the second interface.
   • CConfigure LACP on the ADC and set the switch to passive mode.
   • DConfigure a static LAG on the ADC and static trunking on the switch.
   Reveal Solution Discussion Select an answer first
6. 5foundation · easy

   Which command is used to add an interface to a link aggregation group on a Citrix ADC?

   • Aset interface <interface> -la <name>
   • Bbind la channel <name> <interface>
   • Cadd la channel <name> -ifnum <interface>
   • Dcreate la group <name> -interfaces <interface>
   Reveal Solution Discussion Select an answer first