Configure Link Aggregation CCA-APPDS-GATEWAY Practice Questions (Page 3)

Questions 11–15

1. 11application · medium

   After configuring a LAG on a Citrix ADC, the administrator wants to verify that traffic is being load-balanced across the member interfaces. Which command or tool should be used?

   • Ashow lag
   • Btraceroute
   • Cping
   • Dshow arp
   Reveal Solution Discussion Select an answer first
2. 12application · medium

   A Citrix ADC is being configured as a gateway. The administrator needs to combine four 1 Gbps interfaces into a single logical link to increase throughput. The switch supports LACP. Which steps should the administrator take?

   • AEnable jumbo frames on all four interfaces and increase the MTU.
   • BCreate a LAG, add the four interfaces, and configure LACP on the ADC and the switch.
   • CCreate a VLAN, add the four interfaces to the VLAN, and enable routing between them.
   • DConfigure each interface with a separate IP address and use policy-based routing.
   Reveal Solution Discussion Select an answer first
4. 13foundation · easy

   What is a common cause of LACP negotiation failure on a Citrix ADC link aggregation group?

   • AThe ADC is not configured with an IP address on the LA channel
   • BThe ADC has too many interfaces in the aggregation group
   • CThe interfaces are using different speed and duplex settings
   • DThe switch port is configured for static aggregation instead of LACP
   Reveal Solution Discussion Select an answer first
5. 14foundation · easy

   What is the primary purpose of configuring link aggregation on a Citrix ADC?

   • ATo provide a dedicated management interface separate from data traffic
   • BTo enable the ADC to use a single physical interface for all traffic, simplifying management
   • CTo combine multiple physical interfaces into a single logical link, increasing bandwidth and providing redundancy
   • DTo increase the speed of a single physical interface by changing its duplex settings
   Reveal Solution Discussion Select an answer first
6. 15foundation · easy

   Which statement correctly describes LACP (Link Aggregation Control Protocol) link aggregation?

   • AIt is only supported on Citrix ADC appliances, not on switches
   • BIt uses a negotiation protocol to automatically establish and maintain the link bundle
   • CIt provides lower bandwidth than static aggregation because of protocol overhead
   • DIt requires identical manual configuration on both ends and does not use any protocol
   Reveal Solution Discussion Select an answer first