Configure Link Aggregation CCA-APPDS-GATEWAY Practice Questions (Page 2)

Questions 6–10

1. 6foundation · easy

   What does the 'show la channel' output indicate when a link aggregation group is operating correctly?

   • AAll member interfaces are listed as UP and the group state is UP
   • BThe group shows a DOWN state but interfaces are UP
   • CThe group is configured but no interfaces are listed
   • DThe group shows a PARTIAL state with some interfaces UP
   Reveal Solution Discussion Select an answer first
2. 7application · medium

   An administrator is configuring link aggregation on a Citrix ADC. The switch is configured for LACP passive mode. The administrator wants to ensure the LAG is established. Which LACP mode should be configured on the ADC?

   • APassive
   • BActive
   • CStatic
   • DOff
   Reveal Solution Discussion Select an answer first
4. 8application · medium

   A Citrix ADC has a LAG configured with LACP. The switch shows the LAG as 'up' but the ADC shows the LAG as 'down'. The administrator suspects a configuration mismatch. What should the administrator check first?

   • AThe VLAN configuration on the switch ports.
   • BThe IP address configuration on the LAG interface.
   • CThe MTU settings on the ADC interfaces.
   • DThe LACP mode on both the ADC and the switch.
   Reveal Solution Discussion Select an answer first
5. 9application · medium

   An administrator is configuring link aggregation on a Citrix ADC. The upstream switch does not support LACP. The administrator needs to combine two 1 Gbps interfaces into a single logical link. What should the administrator configure on the ADC?

   • AA single interface with the speed set to 2 Gbps.
   • BTwo separate VLANs, one per interface, and a routing protocol to load-balance.
   • CA static link aggregation group (LAG) with both interfaces added.
   • DAn LACP LAG with the mode set to active on both interfaces.
   Reveal Solution Discussion Select an answer first
6. 10application · medium

   A company is deploying a Citrix ADC as a gateway for remote users. The network team wants to ensure that if one physical link fails, the ADC remains reachable without requiring a failover to a different appliance. Which feature should be configured?

   • AA static route with a higher metric to a backup gateway.
   • BVLAN trunking with multiple VLANs on a single interface.
   • CLink aggregation with multiple interfaces in a single LAG.
   • DA second ADC in a high-availability pair.
   Reveal Solution Discussion Select an answer first