Configure the NetScaler Networking Model CCA-APPDS-GATEWAY Practice Questions (Page 1)

Questions 1–5

1. 1application · medium

   An organization is deploying a NetScaler MPX appliance with four 10GbE interfaces. They need to connect the appliance to two separate switches for redundancy. The two interfaces connected to switch A will carry production traffic, and the two interfaces connected to switch B will carry management traffic. The administrator wants to maximize throughput and provide link-level redundancy for each traffic type. What should the administrator configure?

   • ACreate a single link aggregation channel with all four interfaces and let the switch handle the traffic separation.
   • BConfigure each interface individually without any channel, and rely on the switch's spanning tree protocol for redundancy.
   • CUse one channel for all four interfaces and configure VLANs to separate management and production traffic.
   • DCreate two separate link aggregation channels, one for each switch, and assign the appropriate interfaces to each.
   Reveal Solution Discussion Select an answer first
2. 2foundation · easy

   Which tool is commonly used on a NetScaler to verify network connectivity and troubleshoot routing issues?

   • Aping
   • Bnslookup
   • Cnetstat
   • Dtraceroute
   Reveal Solution Discussion Select an answer first
4. 3application · medium

   A NetScaler is load balancing an internal web application. The application team has reported that a specific client IP address (203.0.113.50) is generating excessive traffic and causing performance issues. The security team wants to block this client from accessing the VIP (198.51.100.10) while allowing all other traffic. What should the administrator configure?

   • AA route that sends traffic from 203.0.113.50 to a null interface.
   • BAn ACL that denies traffic from 203.0.113.50 to the VIP.
   • CA load balancing virtual server policy that redirects the client to a maintenance page.
   • DA NAT rule that translates the client's IP to a different address.
   Reveal Solution Discussion Select an answer first
5. 4foundation · easy

   What is the purpose of the NetScaler 'show' commands in monitoring and diagnostics?

   • ATo delete the configuration of NetScaler components
   • BTo modify the configuration of NetScaler components
   • CTo display the current configuration and status of NetScaler components
   • DTo save the configuration to the startup configuration
   Reveal Solution Discussion Select an answer first
6. 5foundation · easy

   Which of the following is a required setting when configuring a load balancing virtual server?

   • ASSL certificate
   • BIP address and port
   • CContent switching policy
   • DNAT rule
   Reveal Solution Discussion Select an answer first