2.7 Describe How to Capture Device Status 800-150 Practice Questions (Page 2)

Questions 6–10

1. 6application · medium

   A network administrator runs the 'show interfaces GigabitEthernet0/1' command and sees the output includes 'GigabitEthernet0/1 is up, line protocol is down'. What does this output indicate about the operational state of the interface?

   • AThe interface is administratively down and must be enabled with the 'no shutdown' command.
   • BThe interface is physically disconnected and no cable is attached.
   • CThe interface is fully operational and passing traffic normally.
   • DThe interface is receiving a carrier signal, but there is a Layer 2 or Layer 3 problem preventing the protocol from coming up.
   Reveal Solution Discussion Select an answer first
2. 7application · medium

   A network administrator is troubleshooting a Cisco switch where a user is experiencing slow performance. The administrator suspects the interface is experiencing errors. Which command should the administrator use to see the error counters for a specific interface?

   • Ashow version
   • Bshow interfaces GigabitEthernet0/1
   • Cshow ip interface brief
   • Dshow running-config interface GigabitEthernet0/1
   Reveal Solution Discussion Select an answer first
4. 8foundation · easy

   Which Cisco IOS command displays detailed information about the physical and logical characteristics of all interfaces on a router?

   • Ashow processes
   • Bshow version
   • Cshow running-config
   • Dshow interfaces
   Reveal Solution Discussion Select an answer first
5. 9foundation · easy

   A technician runs 'show ip interface brief' and sees that interface GigabitEthernet0/2 is 'administratively down'. What is the most likely cause?

   • AThe interface has a hardware failure.
   • BThe interface is experiencing high traffic.
   • CThe interface has a cable unplugged.
   • DThe interface was manually shut down with the 'shutdown' command.
   Reveal Solution Discussion Select an answer first
6. 10application · medium

   A field technician is replacing a faulty switch at a remote site. Before disconnecting the old device, the technician must ensure that the replacement can be configured identically. Which set of commands should the technician run to capture the necessary device status and configuration for documentation?

   • Ashow interfaces and show ip route
   • Bshow running-config and show version
   • Cshow startup-config and show flash
   • Dshow logging and show inventory
   Reveal Solution Discussion Select an answer first