What is the default QoS trust setting on MS switches?

Ignore all markings and treat all traffic equally

Override all markings with a default priority

An organization is deploying 802.1X on their MS switches. They want to allow a specific printer that does not support 802.1X to connect to a port. What is the best practice for handling this device?

Create an access policy that allows the printer's MAC address without authentication.

Configure the printer with 802.1X credentials.

Disable 802.1X on the port entirely.

Connect the printer to a different switch that does not have 802.1X enabled.

A network administrator is troubleshooting voice quality issues on an MS switch. The VoIP phones are configured to tag traffic with DSCP EF. The switch QoS policy is set to 'Trust' DSCP tags. However, voice traffic is still experiencing jitter. What should the administrator check first?

Ensure the switch ports are set to 1 Gbps full duplex.

Verify that the upstream router is also trusting DSCP tags.

Verify that the DSCP-to-queue mapping on the switch places EF traffic in the highest-priority queue.

Check if the VoIP phones are using the correct VLAN.

CiscoMeraki Solutions Specialist (ECMS)

Domain 3Objective 2

3.2 Configuring MS Switches 500-220 Practice Questions (Page 3)

Part of the Implementation domain, which accounts for 25% of the 500-220 exam. Cisco does not publish an official question count, but from its 90-minute exam (~35–60 total, ~9–15 in this domain), expect 2–3 from this objective — we provide 30 practice questions to prepare you well beyond it. (estimate)

30questions here

6free pages

8concepts

25%of the exam

Questions 11–15

11foundation · easy
What is the default QoS trust setting on MS switches?
Select an answer first
12foundation · easy
Which dynamic routing protocol can be configured on MS switches in the Meraki dashboard?
Select an answer first
13application · medium
An organization is deploying 802.1X on their MS switches. They want to allow a specific printer that does not support 802.1X to connect to a port. What is the best practice for handling this device?
Select an answer first
14expert · hard
A network administrator is troubleshooting voice quality issues on an MS switch. The VoIP phones are configured to tag traffic with DSCP EF. The switch QoS policy is set to 'Trust' DSCP tags. However, voice traffic is still experiencing jitter. What should the administrator check first?
Select an answer first
15foundation · easy
Which of the following can be used to identify a device in an access policy on an MS switch?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to 500-220

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Cisco. “500-220” is a trademark of its owner, used for identification only.

3.2 Configuring MS Switches 500-220 Practice Questions (Page 3)

Questions 11–15

What is the default QoS trust setting on MS switches?

Which dynamic routing protocol can be configured on MS switches in the Meraki dashboard?

An organization is deploying 802.1X on their MS switches. They want to allow a specific printer that does not support 802.1X to connect to a port. What is the best practice for handling this device?

A network administrator is troubleshooting voice quality issues on an MS switch. The VoIP phones are configured to tag traffic with DSCP EF. The switch QoS policy is set to 'Trust' DSCP tags. However, voice traffic is still experiencing jitter. What should the administrator check first?

Which of the following can be used to identify a device in an access policy on an MS switch?

Keep studying — Implementation