Which of the following is a benefit of using switch configuration replication?

Increases the switch's forwarding performance

Provides automatic failover between switches

Ensures consistent configuration across multiple switches

Secures the network from unauthorized access

What is the purpose of switch configuration replication in the Meraki dashboard?

To monitor the performance of multiple switches

To back up the switch configuration to a local file

To update the firmware of multiple switches

To copy the configuration of one switch to other switches for consistency

What is the purpose of Quality of Service (QoS) in a Meraki switching network?

To increase the total bandwidth of the switch

To secure the network from unauthorized access

To prioritize certain types of traffic to ensure performance

To monitor network traffic for troubleshooting

A branch office uses an MS switch stack with SVIs for its local VLANs. The switch stack is connected to a partner network via a single router that does not run a dynamic routing protocol. The partner network uses the 172.16.0.0/16 range. What must be configured on the MS switch to allow the branch VLANs to reach the partner network?

OSPF on the interface connected to the partner router.

A new SVI for the 172.16.0.0/16 network.

A static route for 172.16.0.0/16 with the partner router's IP address as the next hop.

A default route pointing to the partner router's IP address.

In the Meraki dashboard, where would you configure QoS settings for an MS switch?

Network-wide > Configure > General

Switch > Configure > Access policies

Switch > Monitor > Switch ports

CiscoMeraki Solutions Specialist (ECMS)

Domain 3Objective 2

3.2 Configuring MS Switches 500-220 Practice Questions (Page 2)

Part of the Implementation domain, which accounts for 25% of the 500-220 exam. Cisco does not publish an official question count, but from its 90-minute exam (~35–60 total, ~9–15 in this domain), expect 2–3 from this objective — we provide 30 practice questions to prepare you well beyond it. (estimate)

30questions here

6free pages

8concepts

25%of the exam

Questions 6–10

6foundation · easy
Which of the following is a benefit of using switch configuration replication?
Select an answer first
7foundation · easy
What is the purpose of switch configuration replication in the Meraki dashboard?
Select an answer first
8foundation · easy
What is the purpose of Quality of Service (QoS) in a Meraki switching network?
Select an answer first
9application · medium
A branch office uses an MS switch stack with SVIs for its local VLANs. The switch stack is connected to a partner network via a single router that does not run a dynamic routing protocol. The partner network uses the 172.16.0.0/16 range. What must be configured on the MS switch to allow the branch VLANs to reach the partner network?
Select an answer first
10foundation · easy
In the Meraki dashboard, where would you configure QoS settings for an MS switch?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to 500-220

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Cisco. “500-220” is a trademark of its owner, used for identification only.