5.10 Configure and Verify WLAN Within the GUI Using WPA2 PSK 200-301 Practice Questions (Page 6)

Questions 26–30

1. 26application · medium

   A small branch office has a Cisco wireless LAN controller (WLC) managed through its GUI. The administrator needs to provide Wi-Fi access for guests with a passphrase that is easy to remember. The guests should not be able to see each other's traffic. The administrator creates a new WLAN and configures WPA2 PSK. Which additional setting must be configured to meet the guest isolation requirement?

   • ASet the WLAN's Interface to a VLAN that has no default gateway.
   • BEnable the WLAN's Broadcast SSID option and set the client disassociation timeout to 60 seconds.
   • CConfigure the WLAN with a separate SSID and a different WPA2 passphrase.
   • DEnable Peer-to-Peer Blocking on the WLAN's Advanced tab.
   Reveal Solution Discussion Select an answer first
2. 27application · medium

   A network administrator is configuring a new WLAN on a Cisco 9800 wireless controller using the GUI. The WLAN must support WPA2 PSK with a passphrase of 'Cisco12345'. The administrator creates the WLAN profile, sets the SSID to 'CorpWiFi', and selects WPA2 PSK. When saving, the controller rejects the configuration. What is the most likely cause?

   • AThe passphrase is fewer than 8 characters.
   • BThe SSID is already in use by another WLAN on the controller.
   • CThe WLAN profile must be assigned to a policy profile before it can be saved.
   • DWPA2 PSK requires a minimum passphrase of 16 characters.
   Reveal Solution Discussion Select an answer first
4. 28expert · hard

   A network admin has configured a new WPA2 PSK WLAN on a Cisco 9800 controller. The WLAN is enabled and assigned to a VLAN. However, clients cannot connect. The admin checks the GUI and sees that the WLAN is listed as 'Enabled' but the AP does not show the WLAN. What is the most likely cause?

   • AThe passphrase is incorrect
   • BThe WLAN is not assigned to any AP or AP group
   • CThe WLAN is set to WPA2 Enterprise
   • DThe VLAN is not configured on the switch
   Reveal Solution Discussion Select an answer first
5. 29foundation · easy

   After entering the profile name and SSID for a new WLAN in the Cisco WLC GUI, what is the next step to complete the WLAN creation?

   • AClick the Enable checkbox to activate the WLAN
   • BClick Save Configuration to commit the WLAN
   • CClick Apply and then configure security settings
   • DClick the WLAN ID to enable the WLAN
   Reveal Solution Discussion Select an answer first
6. 30application · medium

   A network administrator has just configured a new WLAN with WPA2 PSK on a Cisco 9800 controller. The WLAN is enabled, but no clients can see the SSID. The administrator checks the WLAN's status in the GUI and sees it is 'Enabled'. What should the administrator check next?

   • AVerify that the WLAN is bound to a policy profile and that the policy profile is assigned to the access point's radio.
   • BReboot the access point to apply the WLAN configuration.
   • CCheck the WLAN's security settings to ensure the passphrase is at least 8 characters.
   • DConfirm that the WLAN's SSID is not hidden.
   Reveal Solution Discussion Select an answer first