Logical Routing and Networking Services VCP-NV Practice Questions (Page 4)

Questions 16–20

1. 16foundation · easy

   What is the primary role of logical routing in NSX within a virtualized networking environment?

   • ATo manage physical routers and switches from a central NSX interface
   • BTo enforce security policies at the hypervisor kernel level
   • CTo replace the need for any physical network infrastructure
   • DTo provide routing between virtual networks and to physical networks using software-based gateways
   Reveal Solution Discussion Select an answer first
2. 17foundation · easy

   What is the purpose of a static route on an NSX Tier-0 or Tier-1 gateway?

   • ATo automatically failover to a standby gateway in case of failure
   • BTo filter traffic based on source and destination IP addresses
   • CTo manually define a path to a specific network that is not learned dynamically
   • DTo dynamically learn routes from neighboring routers using OSPF
   Reveal Solution Discussion Select an answer first
4. 18application · medium

   An NSX administrator has a Tier-0 gateway with a static route to a physical network 10.10.0.0/16 via next-hop 192.168.1.1. The administrator notices that traffic from a VM on a Tier-1 segment to a host on the 10.10.0.0/16 network is not working. The VM can ping the Tier-1 gateway. What is the most likely cause of the issue?

   • AThe Tier-0 gateway is not configured for distributed routing.
   • BThe VM's default gateway is not set correctly.
   • CThe static route on the Tier-0 gateway is incorrect.
   • DThe Tier-1 gateway does not have a route to 10.10.0.0/16.
   Reveal Solution Discussion Select an answer first
5. 19foundation · easy

   What is the purpose of configuring OSPF on an NSX Tier-0 gateway?

   • ATo provide dynamic routing between the logical network and physical routers
   • BTo enable load balancing between multiple Tier-1 gateways
   • CTo provide routing between virtual machines on the same segment
   • DTo provide encryption for traffic between sites
   Reveal Solution Discussion Select an answer first
6. 20expert · hard

   An NSX administrator is designing a Tier-0 gateway for a mission-critical application. The application requires high availability and must be able to handle a failover without dropping existing connections. The administrator is considering active-standby and active-active modes. What is a key difference that should influence the decision?

   • AActive-standby mode provides higher throughput than active-active mode.
   • BActive-active mode provides faster failover than active-standby mode.
   • CActive-standby mode is simpler to configure for stateful services like NAT.
   • DActive-active mode requires fewer Edge nodes than active-standby mode.
   Reveal Solution Discussion Select an answer first