Logical Routing and Networking Services VCP-NV Practice Questions (Page 1)

Questions 1–5

1. 1foundation · easy

   What is the primary purpose of a Tier-0 gateway in NSX?

   • ATo provide DHCP and DNS services to virtual machines
   • BTo provide load balancing for web applications
   • CTo provide routing between workloads within the same logical segment
   • DTo connect the logical network to the physical network and provide north-south connectivity
   Reveal Solution Discussion Select an answer first
2. 2foundation · easy

   What is the purpose of SNAT (Source NAT) in NSX?

   • ATo translate the destination IP address of inbound traffic
   • BTo encrypt traffic between sites
   • CTo translate the source IP address of outbound traffic to a different address
   • DTo provide load balancing across multiple servers
   Reveal Solution Discussion Select an answer first
4. 3foundation · easy

   What is Equal Cost Multipath (ECMP) routing in NSX?

   • AA method to encrypt traffic between gateways
   • BA method to load balance traffic across multiple equal-cost paths to the same destination
   • CA method to provide failover between active and standby gateways
   • DA method to prioritize traffic based on QoS
   Reveal Solution Discussion Select an answer first
5. 4foundation · easy

   What is the role of the Tier-0 gateway in a logical routing packet walk for north-south traffic?

   • ATo provide DHCP services to virtual machines
   • BTo provide the exit point from the logical network to the physical network
   • CTo route traffic between virtual machines on different segments
   • DTo perform NAT and firewall inspection for all traffic
   Reveal Solution Discussion Select an answer first
6. 5expert · hard

   A managed service provider (MSP) is using NSX to offer network services to multiple tenants. Each tenant has its own Tier-1 gateway and requires separate routing tables to ensure isolation. The MSP wants to use a single Tier-0 gateway to connect all tenants to the physical network. However, the physical network requires that each tenant's routes be isolated from each other. Which feature should the MSP use on the Tier-0 gateway to achieve this?

   • AUse VRF Lite to create multiple virtual routing and forwarding instances on the Tier-0 gateway.
   • BUse a separate Tier-1 gateway for each tenant and rely on the Tier-0 gateway's routing table.
   • CConfigure a separate Tier-0 gateway for each tenant.
   • DConfigure route filtering on the Tier-0 gateway to prevent route leakage between tenants.
   Reveal Solution Discussion Select an answer first