How to Configure Cisco Nexus Switches CISCO-NETAPP-FLEXPOD-IMPLEMENTATION-ADMINISTRATION-SPECIALIST Practice Questions (Page 2)

Questions 6–10

1. 6foundation · medium

   A network engineer is configuring a port-channel on a Cisco Nexus switch to connect to a server that supports IEEE 802.3ad. Which port-channel mode must be configured on the Nexus switch to use Link Aggregation Control Protocol (LACP) for this link?

   • Aon
   • Bpassive
   • Cdesirable
   • Dactive
   Reveal Solution Discussion Select an answer first
2. 7application · medium

   A FlexPod environment requires separate VLANs for NFS storage traffic (VLAN 100), iSCSI storage traffic (VLAN 200), and management traffic (VLAN 300). The engineer is configuring a pair of Nexus switches that will connect to the storage controllers and compute nodes. The storage controllers will use VLAN 100 and VLAN 200, while the compute nodes will use VLAN 200 and VLAN 300. The engineer must ensure that the switches can carry the required VLANs on the links to the storage and compute nodes. Which configuration should the engineer apply?

   • ACreate the VLANs only on the switch connected to the storage controllers, and configure the inter-switch link as an access port.
   • BCreate the VLANs on both switches, but configure the links to storage and compute as access ports in VLAN 1.
   • CCreate only VLAN 200 on both switches, and configure all links as access ports in VLAN 200.
   • DCreate all three VLANs on both switches, and configure the links to storage and compute as trunk ports with the appropriate allowed VLAN lists.
   Reveal Solution Discussion Select an answer first
4. 8foundation · easy

   Which command adds a description to an interface on a Cisco Nexus switch?

   • Aswitch(config-if)# description To-NetApp-A
   • Bswitch(config-if)# name To-NetApp-A
   • Cswitch(config-if)# interface description To-NetApp-A
   • Dswitch(config-if)# remark To-NetApp-A
   Reveal Solution Discussion Select an answer first
5. 9foundation · easy

   In a FlexPod network, which STP port type is recommended for ports connecting to servers to ensure fast convergence?

   • ATrunk port
   • BNetwork port
   • CEdge port (portfast)
   • DNormal port
   Reveal Solution Discussion Select an answer first
6. 10application · medium

   A FlexPod design uses two Nexus switches in a vPC pair to provide redundancy for the compute nodes. The compute nodes will use LACP port-channels to connect to both switches. The engineer must configure the vPC domain, peer link, and member ports. Which configuration step is essential for the vPC to function correctly?

   • AConfigure the peer link as a single physical link and set the vPC domain ID.
   • BConfigure the vPC member ports as regular port-channels without associating them with the vPC domain.
   • CConfigure the vPC domain ID and peer keepalive, but do not configure a peer link because the switches use the management network.
   • DConfigure a peer link between the two switches using a port-channel, and set the vPC domain ID and peer keepalive.
   Reveal Solution Discussion Select an answer first