Reviewing and Preparing a Site for Implementation of E-Series CERTIFIED-IMPLEMENTATION-ENGINEER-SAN-E-SERIES Practice Questions (Page 2)

Questions 6–10

1. 6application · medium

   A company is planning to install an E-Series system in a colocation facility. The administrator has collected the floor plan, power specifications, and network diagrams. During the site review, the administrator notices that the floor plan shows the storage rack placed with its rear panel facing a wall, leaving only 0.6 meters (24 inches) of clearance. What should the administrator do?

   • AMove the rack to a different location without updating the floor plan.
   • BInstall the system anyway and rely on the front access for all maintenance.
   • CRequest a revised floor plan that places the rack with at least 1 meter (39 inches) of rear clearance.
   • DProceed with installation because the clearance meets the minimum service requirement.
   Reveal Solution Discussion Select an answer first
2. 7foundation · easy

   Which environmental factor must be assessed to ensure it meets E-Series system specifications?

   • AFirmware version
   • BNetwork latency
   • CDisk rotation speed
   • DAmbient temperature
   Reveal Solution Discussion Select an answer first
4. 8application · medium

   An administrator is preparing for an E-Series installation. The administrator has collected the floor plan, power specifications, and network diagrams. During the review, the administrator notices that the network diagram does not show the management network VLAN. What should the administrator do?

   • AAssume the management network uses the default VLAN and proceed.
   • BProceed with the installation and configure the management network after installation.
   • CRequest the missing network diagram information from the network team.
   • DSkip the management network configuration and only set up the data network.
   Reveal Solution Discussion Select an answer first
5. 9expert · hard

   A data center is installing an E-Series system. The room has a humidity control system that maintains 45% relative humidity. However, the room is located in a region with high humidity, and the administrator is concerned about condensation. The pre-installation checklist requires verifying environmental conditions. What is the best action?

   • AMonitor the humidity during installation and adjust if necessary.
   • BVerify that the humidity control system can maintain the specified range under all conditions, including seasonal changes.
   • CInstall a dehumidifier to reduce the humidity further.
   • DProceed with the installation because the humidity is within the specified range.
   Reveal Solution Discussion Select an answer first
6. 10application · medium

   A technician is performing a hardware inventory check for an E-Series system. The packing list includes two controllers, but the technician finds only one controller. What should the technician do?

   • AContact the supplier to resolve the missing controller.
   • BUse a controller from another system as a temporary replacement.
   • CInstall the single controller and add the second one later.
   • DProceed with the installation using the single controller.
   Reveal Solution Discussion Select an answer first