Reviewing and Preparing a Site for Implementation of E-Series CERTIFIED-IMPLEMENTATION-ENGINEER-SAN-E-SERIES Practice Questions (Page 1)

Questions 1–5

1. 1foundation · easy

   What is the purpose of a hardware inventory check before installing an E-Series system?

   • ATo configure the RAID levels for the disk groups
   • BTo update the system's firmware to the latest version
   • CTo verify that all required components are present and compatible
   • DTo assign IP addresses to the storage controllers
   Reveal Solution Discussion Select an answer first
2. 2expert · hard

   An administrator is planning an E-Series installation. The documentation includes a floor plan that shows the rack location, but the power specifications are outdated. The administrator has also received a hardware inventory list that indicates a mix of drive sizes. The administrator must ensure the installation is accurate. What should the administrator do?

   • AAssume the power specifications are correct and focus on the hardware inventory.
   • BRequest updated power specifications and verify the hardware inventory against the system requirements.
   • CProceed with the installation and adjust the power connections later.
   • DUse the outdated power specifications and verify the hardware inventory.
   Reveal Solution Discussion Select an answer first
4. 3foundation · easy

   During a site preparation review for an E-Series system, which of the following must be verified BEFORE implementation begins?

   • AThe customer's preferred storage management software version
   • BThe number of LUNs to be presented to the host
   • CThe IP address scheme for the management network
   • DAvailability of adequate power, cooling, space, and cabling
   Reveal Solution Discussion Select an answer first
5. 4application · medium

   An administrator is about to install an E-Series system. The pre-installation checklist includes verifying power, cooling, space, and cabling. The administrator has confirmed that the power outlets are correctly rated and the cooling is adequate. However, the network diagrams show that the storage system will be connected to a switch that is already at full capacity. What should the administrator do?

   • AProceed with the installation because the power and cooling are adequate.
   • BInstall the system and connect it later when a port becomes available.
   • CIdentify an available port on the switch or plan for an additional switch before installation.
   • DUpdate the network diagram to show the new connection and proceed.
   Reveal Solution Discussion Select an answer first
6. 5application · medium

   An administrator is completing the pre-installation checklist for an E-Series system. The checklist includes verifying that the rack is anchored to the floor. The administrator finds that the rack is not anchored. What should the administrator do?

   • AAnchor the rack to the floor before proceeding.
   • BProceed with the installation because the rack is stable.
   • CPlace the rack against a wall for stability.
   • DSkip the anchoring step and note it for later.
   Reveal Solution Discussion Select an answer first