A network administrator is monitoring a BGP session and notices that the number of received prefixes is increasing over time. What could this indicate?

A misconfigured export policy on the peer.

A company has two BGP routers, R1 and R2, both connected to the same ISP. They want to load-balance outbound traffic across both links. Which configuration should be used?

Configure a static route with equal-cost paths.

Configure different local preferences on each router.

Configure both routers with the same local preference and rely on ECMP.

Use AS path prepending on one router.

A BGP route is not being installed in the routing table. The route is received from an eBGP peer and is visible in 'show bgp neighbor 192.0.2.1 received-routes'. The next hop is reachable. What is the most likely cause?

The route is not in the BGP table.

The route is not advertised by the peer.

The route is rejected by an import policy.

A BGP session between two routers is stuck in the Active state. What is the most likely cause?

The local router has a route policy that rejects all incoming routes.

The remote router is not reachable or is not listening on TCP port 179.

The BGP hold timer has expired.

The local router has received an invalid BGP OPEN message.

Juniper NetworksCertified Professional, Enterprise Routing and Switching (JNCIP-ENT)

Domain 2Objective 9

Configuration, Troubleshooting, and Monitoring in Scenario-Based Contexts JN0-650 Practice Questions (Page 2)

Part of the BGP domain, which makes up ~22% of our current practice bank. Juniper Networks does not publish an official question count, but from its 90-minute exam (~35–60 total, ~8–13 in this domain), expect 1–1 from this objective — we provide 11 practice questions to prepare you well beyond it. (estimate)

11questions here

3free pages

3concepts

Questions 6–10

6application · medium
A network administrator is monitoring a BGP session and notices that the number of received prefixes is increasing over time. What could this indicate?
Select an answer first
7foundation · easy
An administrator needs to configure a BGP peer that should only accept incoming BGP connections and never initiate them. Which BGP configuration statement enables this behavior?
Select an answer first
8application · medium
A company has two BGP routers, R1 and R2, both connected to the same ISP. They want to load-balance outbound traffic across both links. Which configuration should be used?
Select an answer first
9expert · hard
A BGP route is not being installed in the routing table. The route is received from an eBGP peer and is visible in 'show bgp neighbor 192.0.2.1 received-routes'. The next hop is reachable. What is the most likely cause?
Select an answer first
10foundation · easy
A BGP session between two routers is stuck in the Active state. What is the most likely cause?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to JN0-650

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Juniper Networks. “JN0-650” is a trademark of its owner, used for identification only.