What does the 'show route forwarding-table' command display that is useful for verifying load balancing?

The actual next hops installed in the forwarding table for each prefix.

The BGP session state and uptime.

The configuration of the BGP group.

The BGP path selection criteria for each route.

What is the effect of configuring 'multipath' without the 'multiple-as' option in BGP?

The router installs only the best path in the forwarding table.

All paths regardless of AS are considered for load balancing.

BGP sessions are established with non-directly connected peers.

Only paths from the same neighboring AS are considered for load balancing.

What is the primary purpose of BGP multipath?

To establish BGP sessions with peers that are not directly connected.

To prefer paths with a shorter AS path length.

To reduce the number of BGP updates sent to peers.

To enable load balancing across multiple equal-cost BGP paths.

A network engineer has configured BGP multipath on a router. The routing table shows two active BGP paths for a prefix, but the forwarding table only shows one next hop. What is the most likely reason?

The BGP session is using multihop.

The two paths have different next-hop reachability.

The router is using per-packet load balancing.

What is the purpose of BGP multihop?

To load-balance traffic across multiple equal-cost paths.

To prefer paths with a higher local preference.

To establish a BGP session with a peer that is not directly connected.

To reduce the number of BGP updates sent to peers.

Juniper NetworksCertified Professional, Enterprise Routing and Switching (JNCIP-ENT)

Domain 2Objective 5

Load Balancing (multipath, Multihop, Forwarding Table) JN0-650 Practice Questions (Page 1)

Part of the BGP domain, which makes up ~22% of our current practice bank. Juniper Networks does not publish an official question count, but from its 90-minute exam (~35–60 total, ~8–13 in this domain), expect 1–1 from this objective — we provide 13 practice questions to prepare you well beyond it. (estimate)

13questions here

3free pages

6concepts

Questions 1–5

1foundation · easy
What does the 'show route forwarding-table' command display that is useful for verifying load balancing?
Select an answer first
2foundation · easy
What is the effect of configuring 'multipath' without the 'multiple-as' option in BGP?
Select an answer first
3foundation · easy
What is the primary purpose of BGP multipath?
Select an answer first
4expert · hard
A network engineer has configured BGP multipath on a router. The routing table shows two active BGP paths for a prefix, but the forwarding table only shows one next hop. What is the most likely reason?
Select an answer first
5foundation · easy
What is the purpose of BGP multihop?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to JN0-650

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Juniper Networks. “JN0-650” is a trademark of its owner, used for identification only.