Filter-Based VLANs JN0-650 Practice Questions (Page 1)

Questions 1–5

1. 1foundation · easy

   Which of the following packet characteristics can be used in a firewall filter to assign a packet to a filter-based VLAN?

   • ASource MAC address
   • BInterface administrative status
   • CVLAN port membership list
   • DSwitch hostname
   Reveal Solution Discussion Select an answer first
2. 2foundation · easy

   Which command can be used to verify that packets are being assigned to the correct VLAN by a filter-based VLAN?

   • Ashow firewall filter <filter-name>
   • Bshow vlans
   • Cshow ethernet-switching table
   • Dshow interfaces terse
   Reveal Solution Discussion Select an answer first
4. 3foundation · easy

   A packet is not being assigned to the intended VLAN by a filter-based VLAN. Which is the most likely cause?

   • AThe firewall filter is applied in the output direction
   • BThe switch is running out of MAC address space
   • CThe VLAN is not configured with a routing interface
   • DThe spanning-tree protocol is blocking the interface
   Reveal Solution Discussion Select an answer first
5. 4foundation · easy

   Which firewall filter action is used to assign a packet to a specific VLAN in a filter-based VLAN configuration?

   • Acount
   • Bvlan
   • Caccept
   • Dvlan-id
   Reveal Solution Discussion Select an answer first
6. 5foundation · easy

   In which scenario is a filter-based VLAN most useful?

   • AWhen traffic from multiple source MAC addresses on the same interface must be placed into different VLANs
   • BWhen a router must route between two VLANs
   • CWhen all traffic on an interface must be in the same VLAN
   • DWhen a VLAN must span multiple switches using VXLAN
   Reveal Solution Discussion Select an answer first