What is the primary purpose of BGP route reflection?

To enable load balancing across multiple BGP paths

To reduce the number of iBGP sessions required in a full mesh

To increase the AS path length of routes

To suppress unstable routes from being advertised

What is the primary purpose of BGP MED?

To tag routes with a value for policy matching

To increase the AS path length of routes

To influence outbound route selection within an AS

To influence inbound traffic from neighboring ASes

How does BGP fast reroute achieve rapid failover?

By increasing the BGP keepalive interval

By using route damping to suppress failures

By pre-installing backup paths in the forwarding table

You have two equal-cost BGP paths to the same destination via two different providers. You want to load-balance traffic across both paths. What must you configure to allow BGP to install both paths in the routing table?

Enable BGP multipath and ensure the paths are equal-cost.

Configure BGP add-path to advertise both paths.

Use BGP route aggregation to combine the paths.

Set a higher local preference on one path.

Juniper NetworksCertified Professional, Enterprise Routing and Switching (JNCIP-ENT)

Domain 2Objective 7

Advanced BGP Options JN0-650 Practice Questions (Page 7)

Part of the BGP domain, which makes up ~22% of our current practice bank. Juniper Networks does not publish an official question count, but from its 90-minute exam (~35–60 total, ~8–13 in this domain), expect 1–1 from this objective — we provide 50 practice questions to prepare you well beyond it. (estimate)

50questions here

10free pages

20concepts

Questions 31–35

31foundation · easy
What is the primary purpose of BGP route reflection?
Select an answer first
32foundation · easy
What is the primary purpose of BGP MED?
Select an answer first
33foundation · easy
How does BGP fast reroute achieve rapid failover?
Select an answer first
34application · medium
You have two equal-cost BGP paths to the same destination via two different providers. You want to load-balance traffic across both paths. What must you configure to allow BGP to install both paths in the routing table?
Select an answer first
35foundation · easy
In the BGP best path selection algorithm, when is weight compared?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to JN0-650

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Juniper Networks. “JN0-650” is a trademark of its owner, used for identification only.