Cable Map JN0-481 Practice Questions (Page 3)

Questions 11–15

1. 11foundation · easy

   Which two sources of information are used by Apstra to generate the cable map?

   • ADHCP leases and DNS records
   • BLLDP neighbor information and device configurations
   • CRouting tables and ARP caches
   • DSNMP traps and syslog messages
   Reveal Solution Discussion Select an answer first
2. 12application · medium

   An engineer is looking at the Apstra cable map and notices that a link between two devices is shown as 'connected', but the engineer knows the devices are in different buildings. What is the most likely source of this information?

   • AManual entry by the network administrator.
   • BSNMP traps from the devices.
   • CThe device configurations pushed from the blueprint.
   • DLLDP neighbor discovery from the devices.
   Reveal Solution Discussion Select an answer first
4. 13application · medium

   A leaf-spine fabric is experiencing intermittent connectivity between leaf-2 and spine-3. The Apstra cable map shows the link as 'connected' but the link flaps every few minutes. The engineer suspects a cabling issue. What should the engineer do first?

   • AReconfigure the link in the Apstra blueprint to match the discovered cabling.
   • BCheck the cable map for the physical path and verify the cable is seated correctly at both ends.
   • CDisable LLDP on both devices to stop the link from flapping.
   • DIgnore the cable map and check the device logs for interface errors.
   Reveal Solution Discussion Select an answer first
5. 14foundation · easy

   How does the cable map help detect discrepancies between the design and the actual physical cabling?

   • ABy disabling any ports that do not match the design
   • BBy generating a new design based on the actual cabling
   • CBy showing the expected links from the design and highlighting mismatches
   • DBy automatically re-cabling the network to match the design
   Reveal Solution Discussion Select an answer first
6. 15application · medium

   A network architect is explaining the purpose of the cable map to a new engineer. Which statement accurately describes the role of the cable map in Apstra's build and deploy phases?

   • AIt shows the logical topology of the network, including VLANs and routing protocols.
   • BIt replaces the need for LLDP and other discovery protocols.
   • CIt provides a visual representation of the physical cabling between devices, used to validate and troubleshoot connectivity.
   • DIt is used to configure devices automatically based on the physical cabling.
   Reveal Solution Discussion Select an answer first