Deploy Modes JN0-481 Practice Questions (Page 1)

Questions 1–5

1. 1application · medium

   An organization is migrating its data center fabric to Apstra. The network team is experienced with the existing environment but is new to Apstra. They are concerned about the risk of a full-fabric configuration push causing an outage if there is an error. They want to deploy the configuration to a pair of leaf switches first, verify that traffic flows correctly, and then deploy to the rest of the fabric. Which deploy mode should be selected in the Apstra blueprint?

   • ASingle-stage deploy mode
   • BTwo-stage deploy mode
   • CDeploy mode is not relevant; the team should use the commit and confirm feature on each device
   • DZTP deploy mode
   Reveal Solution Discussion Select an answer first
2. 2application · medium

   A network engineer is setting up ZTP for a new fabric. The switches are connected to the management network and will receive their IP addresses via DHCP. The engineer has configured the DHCP server to provide the IP address and the next-server option. What additional information must the DHCP server provide for the switches to successfully discover the Apstra server and download their configuration?

   • AThe management VLAN ID
   • BThe hostname of the Apstra server
   • CThe serial number of each switch
   • DThe IP address or URL of the Apstra server and the configuration file name
   Reveal Solution Discussion Select an answer first
4. 3foundation · easy

   How does ZTP benefit the deployment process in Apstra?

   • AIt reduces the need for on-site personnel to manually configure each device.
   • BIt increases the time required to deploy new devices.
   • CIt requires each device to be configured via console before connecting to the network.
   • DIt is only useful for small networks with a few devices.
   Reveal Solution Discussion Select an answer first
5. 4application · medium

   A network team is deploying a new fabric and has chosen two-stage deploy mode. They have completed the first stage, deploying to a pair of leaf switches, and have validated that the configuration is working correctly. What is the next step in the two-stage deploy process?

   • ARedeploy the first stage to the same devices to ensure consistency
   • BSwitch to single-stage deploy mode for the remaining devices
   • CProceed to the second stage and deploy to the remaining devices
   • DUse ZTP to re-provision the remaining devices
   Reveal Solution Discussion Select an answer first
6. 5foundation · easy

   What is a key advantage of two-stage deploy mode over single-stage in Apstra?

   • AIt applies configuration faster than single-stage because it skips validation.
   • BIt eliminates the need for ZTP during device provisioning.
   • CIt allows configuration to be reviewed and approved before it is applied to devices.
   • DIt automatically rolls back configuration if a device fails to apply it.
   Reveal Solution Discussion Select an answer first