Deploy Modes JN0-481 Practice Questions (Page 2)

Questions 6–10

1. 6foundation · easy

   What is the primary purpose of the deploy modes in Apstra?

   • ATo select which routing protocol is used in the fabric.
   • BTo define the physical topology of the data center fabric.
   • CTo control the timing and process of applying configuration to network devices.
   • DTo determine the licensing requirements for Apstra.
   Reveal Solution Discussion Select an answer first
2. 7application · medium

   A network engineer is provisioning 20 new leaf switches in a remote data center. The switches are being shipped directly from the vendor and will be racked and cabled by on-site staff who have no network expertise. The engineer wants the switches to be automatically discovered, configured, and brought into the Apstra-managed fabric with minimal manual intervention. The engineer has already created the blueprint and staged the intended configuration. What is the most appropriate approach to achieve this?

   • AUse Apstra's import function to manually add each switch's serial number and management IP before deploying
   • BUse ZTP so the switches boot, discover the Apstra server, and receive their configuration automatically
   • CUse two-stage deploy mode to deploy to half the switches, then the other half
   • DUse single-stage deploy mode after the on-site staff manually configure the management IP on each switch
   Reveal Solution Discussion Select an answer first
4. 8foundation · easy

   In two-stage deploy mode, what happens during the first stage?

   • AConfiguration is deleted from the server to ensure a clean slate.
   • BDevices are rebooted to load the new configuration.
   • CConfiguration is applied to devices immediately and then verified.
   • DConfiguration is generated and staged on the Apstra server, but not yet applied to devices.
   Reveal Solution Discussion Select an answer first
5. 9application · medium

   A data center operator is deploying a new leaf-spine fabric in a greenfield facility. The network team has never used Apstra before and wants to validate the initial configuration on a small subset of devices before committing the full configuration to the entire fabric. The devices are already racked, cabled, and powered on, but have no configuration loaded. Which deploy mode should the team use to meet this requirement?

   • AManual CLI configuration on each device
   • BTwo-stage deploy mode
   • CSingle-stage deploy mode
   • DZTP with a single-stage deploy
   Reveal Solution Discussion Select an answer first
6. 10foundation · easy

   Which factor would most likely lead an operator to choose two-stage deploy mode over single-stage?

   • AThe desire to apply configuration as quickly as possible without any review.
   • BThe need for a change-management process that requires review and approval before changes are applied.
   • CThe requirement to support multiple vendors in the fabric.
   • DThe need to use ZTP for initial provisioning.
   Reveal Solution Discussion Select an answer first