Connectivity Templates JN0-481 Practice Questions (Page 1)

Questions 1–5

1. 1foundation · easy

   How is a connectivity template applied to a tenant in Junos?

   • ABy referencing the template in the tenant's logical system configuration
   • BBy using the 'apply-template' command at the shell prompt
   • CBy copying the template configuration into every interface manually
   • DBy sending the template to the tenant via email
   Reveal Solution Discussion Select an answer first
2. 2application · medium

   After applying a new connectivity template to a tenant, the tenant reports that they cannot ping their default gateway. The administrator checks the template configuration and sees that the IRB interface for the tenant's VLAN is configured. What is the most likely reason for the connectivity issue?

   • AThe tenant's logical system is not associated with the template.
   • BThe IRB interface is not assigned an IP address in the template.
   • CThe VLAN is not included in the template.
   • DThe template was not committed.
   Reveal Solution Discussion Select an answer first
4. 3application · medium

   A service provider is onboarding a new tenant that requires two isolated Layer 2 segments (one for production, one for development) that must be completely isolated from each other at Layer 2 and Layer 3. The tenant also needs a single routed gateway for each segment. The network engineer decides to use a connectivity template on the MX series router. Which template component configuration is essential to meet this requirement?

   • ACreate two VLANs and map both to the same routing instance with two IRB interfaces.
   • BCreate a single VLAN with two IRB interfaces, one for production and one for development.
   • CCreate two separate VLANs and map each to a unique routing instance with its own IRB interface.
   • DCreate two routing instances and map both to the same VLAN with a single IRB interface.
   Reveal Solution Discussion Select an answer first
5. 4expert · hard

   A data center architect is designing a connectivity template for a tenant that requires a DMZ network and an internal network. The DMZ network must be isolated from the internal network at Layer 3, but both must be able to reach the internet. The architect plans to use two routing instances. What is the most efficient way to provide internet access to both routing instances?

   • ACreate a third routing instance for internet access and import routes from the DMZ and internal instances.
   • BConfigure a default route in each routing instance pointing to the same upstream router.
   • CConfigure a single default route in one routing instance and leak it to the other.
   • DUse a single routing instance for both networks and use firewall filters to isolate them.
   Reveal Solution Discussion Select an answer first
6. 5foundation · easy

   Which action is part of managing connectivity templates in Junos?

   • ADeleting a template that is no longer needed
   • BUpgrading the device's firmware
   • CChanging the device's hostname
   • DPhysically removing the switch from the rack
   Reveal Solution Discussion Select an answer first