Juniper NetworksCertified Specialist, Service Provider Routing and Switching (JNCIS-SP)
Domain 8Objective 3
IPv6 over IPv4 Tunneling JN0-364 Practice Questions (Page 3)
Part of the IPv6 domain, which makes up ~5% of our current practice bank. Juniper Networks does not publish an official question count, but from its 90-minute exam (~35–60 total, ~2–3 in this domain), expect 1–1 from this objective — we provide 16 practice questions to prepare you well beyond it. (estimate)
16questions here
4free pages
6concepts
Questions 11–15
- 11
A network architect is designing IPv6 connectivity for a small branch office that has a dynamic public IPv4 address from its ISP. The branch needs to reach the IPv6 Internet. The architect wants a solution that requires no manual configuration of tunnel endpoints and works even when the IPv4 address changes. Which tunneling mechanism should be selected?
Select an answer first - 12
What is the primary use case for ISATAP tunneling?
Select an answer first - 13
A network engineer is configuring a 6to4 tunnel on a Junos router with a public IPv4 address of 192.0.2.1. The router must advertise a 6to4 prefix to its internal IPv6 network. Which IPv6 prefix should the engineer assign to the tunnel interface?
Select an answer first - 14
Which tunneling mechanism is designed to allow IPv6 sites to communicate over the IPv4 Internet without pre-configuring tunnel endpoints?
Select an answer first - 15
A junior engineer is troubleshooting an IPv6-over-IPv4 tunnel on a Junos router. The engineer notices that the tunnel interface is up, but IPv6 routes learned over the tunnel are not being installed in the routing table. What is the most likely cause?
Select an answer first
Finished these 5 questions?
Review the revealed explanations, or continue through the curriculum.
Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Juniper Networks. “JN0-364” is a trademark of its owner, used for identification only.