
Juniper NetworksCertified Specialist, Service Provider Routing and Switching (JNCIS-SP)
Domain 3Objective 8
Configure, Monitor, or Troubleshoot IS-IS Interfaces and Adjacencies JN0-364 Practice Questions (Page 3)
Part of the Intermediate System to Intermediate System (IS-IS) domain, which makes up ~12% of our current practice bank. Juniper Networks does not publish an official question count, but from its 90-minute exam (~35–60 total, ~4–7 in this domain), expect 1–1 from this objective — we provide 17 practice questions to prepare you well beyond it. (estimate)
17questions here
4free pages
7concepts
Questions 11–15
- 11
A network administrator is troubleshooting an IS-IS adjacency that is flapping between `Up` and `Down` on a point-to-point link. The `show log` shows that the adjacency is being brought down due to a `hold-time` expiry. The link is a 10GE link with an MTU of 1500 bytes. The administrator checks the `show isis interface` output and sees that the `hello-interval` is set to 10 seconds and the `hold-time` is set to 30 seconds. What is the most likely cause of this issue?
Select an answer first - 12
A network engineer is troubleshooting an IS-IS adjacency that is flapping between `Up` and `Down` on a point-to-point link. The `show log` shows that the adjacency is being brought down due to a `hold-time` expiry. The link is a 10GE link with an MTU of 1500 bytes. What is the most likely cause of this issue?
Select an answer first - 13
Which mismatch is a common cause of IS-IS adjacency failure?
Select an answer first - 14
Which adjacency type is formed between routers in different areas?
Select an answer first - 15
What is a common symptom of an MTU mismatch on an IS-IS interface?
Select an answer first
Finished these 5 questions?
Review the revealed explanations, or continue through the curriculum.
Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Juniper Networks. “JN0-364” is a trademark of its owner, used for identification only.