Juniper NetworksCertified Specialist, Service Provider Routing and Switching (JNCIS-SP)
Domain 3Objective 8
Configure, Monitor, or Troubleshoot IS-IS Interfaces and Adjacencies JN0-364 Practice Questions (Page 1)
Part of the Intermediate System to Intermediate System (IS-IS) domain, which makes up ~12% of our current practice bank. Juniper Networks does not publish an official question count, but from its 90-minute exam (~35–60 total, ~4–7 in this domain), expect 1–1 from this objective — we provide 17 practice questions to prepare you well beyond it. (estimate)
17questions here
4free pages
7concepts
Questions 1–5
- 1
In which scenario would you configure an IS-IS interface as passive?
Select an answer first - 2
Which field in the output of 'show isis adjacency' indicates that an adjacency is fully operational?
Select an answer first - 3
What is the purpose of a Level 1-2 router in IS-IS?
Select an answer first - 4
A network engineer is troubleshooting an IS-IS adjacency that is not forming between two routers. The `show isis adjacency` command shows no neighbors. The engineer checks the `show isis interface` output and sees that the interface is up and the ISO address is configured. The engineer also verifies that the area addresses match. What is the next most likely cause to investigate?
Select an answer first - 5
Which command displays the current state of IS-IS adjacencies on a Junos device?
Select an answer first
Finished these 5 questions?
Review the revealed explanations, or continue through the curriculum.
Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Juniper Networks. “JN0-364” is a trademark of its owner, used for identification only.