Which characteristic best describes BGP when compared to interior gateway protocols (IGPs) like OSPF?

It is designed to scale to the size of the internet

It uses the Dijkstra algorithm to compute shortest paths

It requires a full mesh of adjacencies to avoid loops

It is primarily used within a single enterprise campus

An eBGP router in AS 65001 is advertising the 172.16.0.0/16 route to a peer in AS 65002. The route's next hop is 192.168.1.1. When the router in AS 65002 receives this route, what will the next hop be?

The next hop is set to 0.0.0.0, because the route is locally originated.

192.168.1.2, because the next hop is changed to the receiving interface.

The router's own loopback address, because BGP always uses loopback addresses.

192.168.1.1, because the next hop is not changed for eBGP routes.

When comparing two BGP routes to the same destination, which attribute is preferred if LOCAL_PREF is equal?

Higher origin type (incomplete over IGP)

You are troubleshooting a BGP session that is stuck in the Active state. You have verified that the neighbor IP address and AS number are correctly configured on both sides. What is the most likely cause of this issue?

The BGP NOTIFICATION message is malformed.

The BGP KEEPALIVE timer is set too low.

TCP port 179 is blocked by a firewall between the two routers.

The BGP OPEN message contains an incorrect hold time.

Juniper NetworksCertified Specialist, Enterprise Routing and Switching (JNCIS-ENT)

Domain 7Objective 1

BGP Basic Operation JN0-352 Practice Questions (Page 3)

Part of the BGP domain, which makes up ~13% of our current practice bank. Juniper Networks does not publish an official question count, but from its 90-minute exam (~35–60 total, ~5–8 in this domain), expect 1–1 from this objective — we provide 19 practice questions to prepare you well beyond it. (estimate)

19questions here

4free pages

8concepts

Questions 11–15

11foundation · easy
Which characteristic best describes BGP when compared to interior gateway protocols (IGPs) like OSPF?
Select an answer first
12foundation · easy
In the BGP best path selection algorithm, which criterion is evaluated FIRST?
Select an answer first
13application · medium
An eBGP router in AS 65001 is advertising the 172.16.0.0/16 route to a peer in AS 65002. The route's next hop is 192.168.1.1. When the router in AS 65002 receives this route, what will the next hop be?
Select an answer first
14foundation · easy
When comparing two BGP routes to the same destination, which attribute is preferred if LOCAL_PREF is equal?
Select an answer first
15application · medium
You are troubleshooting a BGP session that is stuck in the Active state. You have verified that the neighbor IP address and AS number are correctly configured on both sides. What is the most likely cause of this issue?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to JN0-352

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Juniper Networks. “JN0-352” is a trademark of its owner, used for identification only.