Configure and Verify the Operation of ZTP SONIC-DEPLOY Practice Questions (Page 3)

Questions 11–15

1. 11foundation · easy

   During the ZTP workflow in Dell SONiC, what typically happens after the switch boots and discovers the provisioning server?

   • AThe switch downloads and applies the configuration file from the server
   • BThe switch generates a new configuration file and uploads it to the server
   • CThe switch erases all existing configurations and reboots
   • DThe switch immediately shuts down to await manual configuration
   Reveal Solution Discussion Select an answer first
2. 12application · medium

   A network administrator is setting up ZTP for a new Dell SONiC switch. The switch is currently in factory-default state. The administrator wants to ensure that after ZTP completes, the switch saves the applied configuration to the startup configuration. What should the administrator do?

   • ADo nothing; ZTP automatically saves the configuration.
   • BEnable the 'persist-config' option in ZTP settings.
   • CInclude a 'copy running-config startup-config' command in the provisioning script or configuration file.
   • DReboot the switch after ZTP completes.
   Reveal Solution Discussion Select an answer first
4. 13application · medium

   An administrator is troubleshooting a Dell SONiC switch that failed to provision via ZTP. The switch obtained an IP address via DHCP, but the provisioning server was unreachable. Which log or status output would most directly indicate this failure?

   • AThe running configuration is empty.
   • BThe DHCP lease is not renewed.
   • CThe ZTP status shows 'failed' with an error indicating the provisioning server could not be reached.
   • DThe switch's management interface is down.
   Reveal Solution Discussion Select an answer first
5. 14application · medium

   A network team is deploying Dell SONiC switches in a lab. They want to test ZTP by pointing the switches to a provisioning server that is not on the same subnet as the switches. The switches will get their IP addresses via DHCP. What must be configured to ensure the switches can reach the provisioning server?

   • AConfigure DHCP option 66 with the provisioning server's IP address or hostname.
   • BConfigure a static route on the switch to the provisioning server.
   • CConfigure the provisioning server as the DHCP server.
   • DPlace the provisioning server on the same subnet as the switches.
   Reveal Solution Discussion Select an answer first
6. 15application · medium

   An administrator has a Dell SONiC switch that was previously configured manually. The administrator now wants to use ZTP to reprovision the switch from a central provisioning server. The switch is currently running with a full configuration. What is the correct first step to enable ZTP on this switch?

   • ADisable the management interface and reboot to force ZTP.
   • BErase the startup configuration and reboot the switch.
   • CEnable ZTP in the running configuration and reboot.
   • DSet the provisioning server IP in the running configuration and save.
   Reveal Solution Discussion Select an answer first