Configure and Verify the Operation of VLT in OS10 POWERSWITCH-DATA-CENTER-DEPLOY Practice Questions (Page 2)

Questions 6–10

1. 6application · medium

   A data center team is deploying two OS10 switches as VLT peers. They have connected the two switches with a 40GbE link for the VLT interconnect and a separate management network link for backup. They have created a VLT domain and assigned a domain ID. Which additional configuration step is required to complete the VLT domain setup before creating VLT LAGs?

   • AConfigure the VLT LAGs on both switches with the same LAG ID and assign the downstream switch ports.
   • BConfigure the VLT interconnect (peer link) with the 'vlt interconnect' command and enable the backup link with 'vlt backup-link'.
   • CEnable spanning-tree BPDU guard on all ports connected to the VLT peers.
   • DAssign a unique VLT MAC address to each peer node.
   Reveal Solution Discussion Select an answer first
2. 7application · medium

   An administrator has configured VLT on a pair of OS10 switches. They want to verify that the VLT interconnect is operational and that both nodes are in a steady state. Which command provides the most direct confirmation of the VLT domain status and peer connectivity?

   • Ashow vlt statistics
   • Bshow vlt
   • Cshow vlt backup-link
   • Dshow vlt mac
   Reveal Solution Discussion Select an answer first
4. 8foundation · easy

   Which OS10 command is used to verify the operational status of a VLT LAG, such as whether it is up and forwarding traffic?

   • Ashow vlt interconnect
   • Bshow vlt backup-link
   • Cshow vlt domain
   • Dshow vlt lag
   Reveal Solution Discussion Select an answer first
5. 9foundation · easy

   In OS10, which command is used to designate a port-channel as the VLT interconnect (peer link) between the two VLT nodes?

   • Apeer-link port-channel 1
   • Bvlt-port-channel 1
   • Cbackup-link 1.1.1.1
   • Dinterface port-channel 1
   Reveal Solution Discussion Select an answer first
6. 10foundation · easy

   What is the role of a VLT LAG in an OS10 VLT domain?

   • AIt is the logical domain identifier that groups the two VLT switches.
   • BIt provides a loop-free path between the two VLT peer switches.
   • CIt carries heartbeat messages between the VLT peers to detect failures.
   • DIt aggregates multiple physical links from a downstream device to both VLT peers.
   Reveal Solution Discussion Select an answer first