Configure and Verify the Operation of VLT in OS10 POWERSWITCH-DATA-CENTER-DEPLOY Practice Questions (Page 1)

Questions 1–5

1. 1foundation · easy

   In an OS10 VLT domain, what is the purpose of the backup link?

   • ATo provide a redundant path for the VLT interconnect to carry data traffic.
   • BTo carry data traffic between the VLT peers when the VLT interconnect is overloaded.
   • CTo connect the VLT peers to the management network for out-of-band management.
   • DTo send heartbeat messages between the VLT peers to detect dual-active scenarios.
   Reveal Solution Discussion Select an answer first
2. 2foundation · easy

   Which OS10 command displays the status of the VLT domain, including the role of the switch (primary or secondary) and the state of the VLT interconnect?

   • Ashow vlt domain
   • Bshow vlt statistics
   • Cshow vlt brief
   • Dshow vlt role
   Reveal Solution Discussion Select an answer first
4. 3application · medium

   An administrator is troubleshooting a VLT deployment on OS10 switches. The 'show vlt' command indicates that the VLT interconnect is down, but the backup link is up. What should the administrator check first?

   • AThe physical connectivity and configuration of the VLT interconnect ports.
   • BThe VLT backup link configuration on both switches.
   • CThe spanning-tree state of the VLT LAG ports.
   • DThe MAC address table on the downstream switch.
   Reveal Solution Discussion Select an answer first
5. 4foundation · easy

   What happens in an OS10 VLT domain when the VLT interconnect fails but the backup link is still operational?

   • AThe secondary switch shuts down all VLT LAGs to prevent a dual-active scenario.
   • BThe switches use the backup link to carry data traffic between them.
   • CBoth switches continue to forward traffic normally as if nothing happened.
   • DThe primary switch immediately reboots to re-establish the VLT interconnect.
   Reveal Solution Discussion Select an answer first
6. 5expert · hard

   A network team is configuring VLT on two OS10 switches. They have a requirement that the VLT domain must be able to handle a failure of the VLT interconnect without causing a traffic outage. They have configured the backup link. What additional configuration is needed to ensure that the VLT domain can detect the interconnect failure and respond quickly?

   • AConfigure the VLT domain with a lower failover timeout.
   • BConfigure the VLT interconnect as a port-channel with multiple physical links.
   • CEnable the VLT backup link to be used for data traffic.
   • DEnsure the backup link is configured and operational, as it is used to detect the interconnect failure.
   Reveal Solution Discussion Select an answer first