Locate PowerMax 2500 and 8500 Hardware Components POWERMAX-INSTALL Practice Questions (Page 4)

Questions 16–19

1. 16application · easy

   A technician is performing a preventive maintenance check on a PowerMax 2500. The technician needs to visually inspect the drive status LEDs. Where should the technician look?

   • AOn the top of the chassis, near the fans
   • BOn the front of each drive carrier
   • COn the midplane, visible through a small window
   • DOn the rear panel, next to the I/O modules
   Reveal Solution Discussion Select an answer first
2. 17foundation · easy

   In the PowerMax 8500 chassis, where are the I/O modules typically located?

   • AAt the rear of the chassis
   • BIn the middle of the chassis
   • CAt the front of the chassis
   • DOn the top of the chassis
   Reveal Solution Discussion Select an answer first
4. 18foundation · easy

   In the PowerMax 2500 chassis, where are the drive bays typically located?

   • AAt the front of the chassis
   • BAt the rear of the chassis
   • COn the side of the chassis
   • DOn the top of the chassis
   Reveal Solution Discussion Select an answer first
5. 19application · easy

   A technician is replacing a failed I/O module in a PowerMax 2500. The technician needs to identify the correct location of the I/O modules. Where are the I/O modules located on the PowerMax 2500?

   • AIn the rear of the chassis, in the upper section
   • BIn the top of the chassis, near the fans
   • CIn the lower rear section, near the power supplies
   • DIn the front of the chassis, below the drive bays
   Reveal Solution Discussion Select an answer first