Locate PowerMax 2500 and 8500 Hardware Components POWERMAX-INSTALL Practice Questions (Page 2)

Questions 6–10

1. 6expert · hard

   A storage team is designing a new data center and must decide between a PowerMax 2500 and 8500. The facility has a very low ceiling, which limits overhead access. The team expects to perform frequent drive replacements and occasional I/O module upgrades. Which model should the team choose to minimize the impact of the low ceiling?

   • APowerMax 2500, because its drives are front-accessible and I/O modules are rear-accessible
   • BPowerMax 8500, because it has no top-mounted components
   • CPowerMax 2500, because its top-mounted fans are the only overhead component
   • DPowerMax 8500, because its drives are front-accessible and I/O modules are rear-accessible
   Reveal Solution Discussion Select an answer first
2. 7application · easy

   An engineer is creating a maintenance guide for a PowerMax 8500. The engineer needs to document the location of the power supplies. Where should the engineer specify the power supplies are located?

   • AIn the top of the chassis, near the fans
   • BIn the middle of the chassis, behind a service door
   • CIn the rear of the chassis, in the lower section
   • DIn the front of the chassis, below the drive bays
   Reveal Solution Discussion Select an answer first
4. 8application · easy

   A technician is preparing to replace a failed power supply in a PowerMax 2500. The technician needs to physically locate the power supply unit. Where should the technician go?

   • ATo the rear of the chassis, in the lower section
   • BTo the side of the chassis, behind a removable panel
   • CTo the top of the chassis, under the fan cover
   • DTo the front of the chassis, behind the drive bezel
   Reveal Solution Discussion Select an answer first
5. 9application · easy

   An engineer is documenting the physical layout of a PowerMax 8500 for a site survey. The engineer needs to identify which component is located in the upper rear section of the chassis. Which component should the engineer document?

   • AThe I/O modules
   • BThe power supplies
   • CThe drive modules
   • DThe cooling fans
   Reveal Solution Discussion Select an answer first
6. 10application · easy

   A storage administrator is planning to add additional I/O connectivity to a PowerMax 8500. The administrator needs to identify where the I/O modules are physically located to plan the installation. Where are the I/O modules on the PowerMax 8500?

   • AIn the middle of the chassis, behind a service door
   • BIn the front of the chassis, above the drive bays
   • CIn the rear of the chassis, in the upper section
   • DIn the top of the chassis, near the fans
   Reveal Solution Discussion Select an answer first