During the power-on of an MX7000 chassis, the management module LCD displays a series of status messages and then the system proceeds to boot. What is the purpose of this process?

To verify that the chassis hardware components are functioning correctly before the operating system loads

To establish a connection to the Dell support portal for updates

To configure the IP address of the management modules automatically

To load the firmware for all compute sleds in the chassis

An MX7000 chassis fails to power on. The power supply LEDs are off, and the facility reports that the circuit breaker is tripped. What is the most likely cause of the power-on failure?

A short circuit in the power supply or power cord

The chassis is in standby mode and the power supplies are intentionally off

The compute sleds are not installed

The management modules are not seated properly

An administrator is powering on an MX7000 chassis with two AC power supplies. After connecting the first power cord, the power supply LED turns green. The administrator then connects the second power cord, but the LED on the second power supply remains off. What should the administrator do?

Proceed with powering on the management modules, as the second supply is in standby

Check the second power cord and the outlet it is connected to

Replace the second power supply with a DC version

Wait for the second power supply to initialize, as it takes longer than the first

An MX7000 chassis fails to power on. The power supply LEDs are green, but the management module LED is off. The administrator has verified that the management module is seated properly. What is the next step to troubleshoot the issue?

Power on the compute sleds first to initialize the chassis

Replace the power supplies with higher-wattage units

Check the management module's serial console for error messages

Reset the chassis by disconnecting and reconnecting the power cords

What is a critical safety consideration when powering on an MX7000 with DC power?

Ensure the DC power source is properly grounded

Connect the DC power cables before grounding the chassis

Dell PowerEdge MX Modular Deploy

Domain 3Objective 2

Describe the Power-On Options POWEREDGE-MX-MODULAR-DEPLOY Practice Questions (Page 3)

Part of the MX7000 Installation domain, which accounts for 17% of the POWEREDGE-MX-MODULAR-DEPLOY exam.

23questions here

5free pages

7concepts

17%of the exam

Questions 11–15

11application · medium
During the power-on of an MX7000 chassis, the management module LCD displays a series of status messages and then the system proceeds to boot. What is the purpose of this process?
Select an answer first
12application · medium
An MX7000 chassis fails to power on. The power supply LEDs are off, and the facility reports that the circuit breaker is tripped. What is the most likely cause of the power-on failure?
Select an answer first
13application · medium
An administrator is powering on an MX7000 chassis with two AC power supplies. After connecting the first power cord, the power supply LED turns green. The administrator then connects the second power cord, but the LED on the second power supply remains off. What should the administrator do?
Select an answer first
14expert · hard
An MX7000 chassis fails to power on. The power supply LEDs are green, but the management module LED is off. The administrator has verified that the management module is seated properly. What is the next step to troubleshoot the issue?
Select an answer first
15foundation · easy
What is a critical safety consideration when powering on an MX7000 with DC power?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to POWEREDGE-MX-MODULAR-DEPLOY

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “POWEREDGE-MX-MODULAR-DEPLOY” is a trademark of its owner, used for identification only.