Which action is part of the recovery procedure for a forgotten LCD PIN on an MX7000?

Performing a factory reset of the entire chassis

Entering a master PIN that is printed on the chassis label

Using the iDRAC interface to reset the LCD PIN

Contacting Dell support to remotely unlock the LCD

How can an administrator verify that the Right Control Panel has been successfully auto-configured after replacement?

By ensuring the new panel is physically secure in the chassis

By checking the iDRAC event log for a 'configuration complete' message

By confirming that the new panel's firmware version matches the original

By checking the chassis LCD for the correct chassis name and status

A technician is unable to access the LCD menu on the Left Control Panel because the PIN was changed by a previous employee and is not documented. The technician has physical access to the chassis and valid credentials for OME-Modular. What is the most appropriate first step to resolve this issue?

Use the OME-Modular CLI to reset the LCD PIN to the default value.

Contact Dell Support to initiate the PIN recovery process with proof of ownership.

Perform a factory reset of the chassis to clear all local settings, including the LCD PIN.

Remove and reinstall the Left Control Panel to clear the PIN.

A technician is about to replace the Right Control Panel in an MX7000 chassis. The chassis is currently powered off for maintenance. What is the correct procedure regarding the chassis power state for the auto-configuration to occur?

The chassis can be powered on after the replacement, and auto-configuration will occur during the next scheduled maintenance window.

The chassis must be powered on and OME-Modular must be operational for auto-configuration to complete.

The chassis power state does not affect auto-configuration; it occurs regardless of whether the chassis is on or off.

The chassis must remain powered off until the new panel is manually configured via OME-Modular.

Under which condition does the Right Control Panel auto-configuration occur?

When the new Right Control Panel is installed and powered on

When the administrator presses a button on the new panel

When the chassis is rebooted after the replacement

When the new panel is connected to a specific port on the chassis

Dell PowerEdge MX Modular Deploy

Domain 5Objective 3

Describe the Left Control Panel LCD PIN Management And/or Right Control Panel Field Replacement Auto-Configuration POWEREDGE-MX-MODULAR-DEPLOY Practice Questions (Page 3)

Part of the MX7000 Troubleshooting domain, which accounts for 8% of the POWEREDGE-MX-MODULAR-DEPLOY exam.

24questions here

5free pages

6concepts

8%of the exam

Questions 11–15

11foundation · easy
Which action is part of the recovery procedure for a forgotten LCD PIN on an MX7000?
Select an answer first
12foundation · easy
How can an administrator verify that the Right Control Panel has been successfully auto-configured after replacement?
Select an answer first
13application · medium
A technician is unable to access the LCD menu on the Left Control Panel because the PIN was changed by a previous employee and is not documented. The technician has physical access to the chassis and valid credentials for OME-Modular. What is the most appropriate first step to resolve this issue?
Select an answer first
14application · medium
A technician is about to replace the Right Control Panel in an MX7000 chassis. The chassis is currently powered off for maintenance. What is the correct procedure regarding the chassis power state for the auto-configuration to occur?
Select an answer first
15foundation · easy
Under which condition does the Right Control Panel auto-configuration occur?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to POWEREDGE-MX-MODULAR-DEPLOY

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “POWEREDGE-MX-MODULAR-DEPLOY” is a trademark of its owner, used for identification only.