Describe the Infrastructure and Out-Of-The-Box Setup on an MX7000 POWEREDGE-MX-MODULAR-DEPLOY Practice Questions (Page 3)

Questions 11–15

1. 11application · medium

   An administrator is performing the initial configuration of an MX7000 via OpenManage Enterprise Modular. The administrator has set the management IP address and admin credentials. The next step in the guided setup wizard is to configure the time settings. Why is this step important before proceeding with further configuration?

   • AIt determines the time zone used for the LCD panel display only
   • BIt synchronizes the compute sleds' operating systems with the chassis clock
   • CIt ensures accurate timestamps for logs and certificates generated by the chassis
   • DIt is required before the I/O modules can be detected by the chassis
   Reveal Solution Discussion Select an answer first
2. 12application · medium

   An administrator is setting up a new MX7000 chassis and wants to integrate it into an existing chassis group that already contains two other MX7000 chassis. The administrator is at the initial configuration wizard step for chassis group membership. What must the administrator provide to join the existing chassis group?

   • AThe fabric configuration of the existing chassis in the group
   • BThe admin password of the new chassis only
   • CThe serial number of the primary chassis in the group
   • DThe management IP address and credentials of the primary chassis in the group
   Reveal Solution Discussion Select an answer first
4. 13application · medium

   During the initial setup of an MX7000, the administrator is configuring the fabrics. The chassis has two Ethernet I/O modules in Fabric A and two Fibre Channel I/O modules in Fabric B. The administrator wants to name the fabrics for easy identification. What is the correct approach to naming the fabrics?

   • AAssign a custom name to Fabric A and Fabric B during the fabric configuration step
   • BThe fabric names are automatically set to the I/O module model numbers
   • CFabric names must be the same as the chassis group name
   • DFabric names can only be changed after the initial setup is complete
   Reveal Solution Discussion Select an answer first
5. 14foundation · easy

   What is the default IP address of the Dell PowerEdge MX7000 management module when accessed for the first time out of the box?

   • A192.168.0.1
   • B192.168.1.1
   • C10.10.10.10
   • D192.168.10.10
   Reveal Solution Discussion Select an answer first
6. 15foundation · easy

   During the initial configuration of the MX7000 using OpenManage Enterprise Modular, which of the following is NOT a required setting that must be configured?

   • AAdmin credentials
   • BTime settings
   • CManagement IP address
   • DFabric naming
   Reveal Solution Discussion Select an answer first