Describe the Steps and Settings Used for the Initial Configuration of a Switch NETWORKING-FOUNDATIONS Practice Questions (Page 5)

Questions 21–25

1. 21foundation · easy

   After making configuration changes, how can you verify that the changes are saved and will survive a reboot?

   • AUse 'show version' to check the software version
   • BUse 'show mac-address-table' to see if MAC addresses are learned
   • CUse 'show interfaces' to check if all ports are up
   • DUse 'show startup-config' and compare it to the running configuration
   Reveal Solution Discussion Select an answer first
2. 22foundation · easy

   During the initial setup dialog, which of the following is typically NOT requested?

   • AEnable password
   • BHostname
   • CManagement IP address
   • DVLAN configuration for all ports
   Reveal Solution Discussion Select an answer first
4. 23foundation · easy

   Which command displays the current running configuration of a switch?

   • Ashow startup-config
   • Bshow interfaces
   • Cshow running-config
   • Dshow version
   Reveal Solution Discussion Select an answer first
5. 24foundation · easy

   Which environmental condition is important to verify before installing a switch in a network rack?

   • AThe rack is located in a room with humidity below 10%
   • BThe rack is painted with a non-conductive coating
   • CThe rack has a UPS with a capacity of at least 2000 VA
   • DThe rack has adequate ventilation and the ambient temperature is within the switch's operating range
   Reveal Solution Discussion Select an answer first
6. 25foundation · easy

   Which command is used to set the domain name on a Dell switch?

   • Adomain-name example.com
   • Bip domain-name example.com
   • Cset domain example.com
   • Dhostname example.com
   Reveal Solution Discussion Select an answer first