Why is labeling cables important during ECS rack setup?

To improve the aesthetic appearance of the rack

To simplify troubleshooting and maintenance

To comply with international safety regulations

To increase the network bandwidth of the connections

A technician is racking ECS nodes in a data center. The technician notices that the rack has a non-standard depth and the cable management arms are not included. The technician must ensure proper rack mounting and cabling. What should the technician do?

Mount the nodes without rails and let them rest on the rack's crossbars

Place the nodes on shelves and use zip ties for cable management

Return the rack and request a standard-depth rack

Use the adjustable rails provided with the ECS hardware and secure cables with Velcro straps

Which site requirement must be verified before installing an ECS system?

A raised floor with a minimum height of 60 cm

Adequate power and cooling capacity for the planned hardware

A dedicated fiber connection to the nearest internet exchange

A backup generator capable of running the entire site for 72 hours

Before installing an ECS system, an administrator performs pre-installation checks. The administrator verifies that all nodes are powered on, network cables are connected, and the management switch is reachable. However, the ECS installation wizard reports that one node is not responding. What should the administrator check next?

Check the node's firmware version

Replace the node's power supply

Verify that the node's IP address is correctly configured and that the VLAN is allowed on the switch port

An administrator is preparing to deploy an ECS system and has received the hardware from Dell. Before starting the installation, the administrator wants to verify that all required components are present and that the system meets the prerequisites. Which action should the administrator take first?

Check the packing list against the received hardware and verify firmware versions

Connect all nodes to the network and power them on

Configure the IP addresses on all nodes

Install the ECS software on the first node

Dell ECS Deploy

Domain 2Objective 1

Prepare the Site and ECS System for Installation ECS-DEPLOY Practice Questions (Page 4)

Part of the ECS Implementation domain, which accounts for 36% of the ECS-DEPLOY exam.

24questions here

5free pages

5concepts

36%of the exam

Questions 16–20

16foundation · easy
Why is labeling cables important during ECS rack setup?
Select an answer first
17application · medium
A technician is racking ECS nodes in a data center. The technician notices that the rack has a non-standard depth and the cable management arms are not included. The technician must ensure proper rack mounting and cabling. What should the technician do?
Select an answer first
18foundation · easy
Which site requirement must be verified before installing an ECS system?
Select an answer first
19application · medium
Before installing an ECS system, an administrator performs pre-installation checks. The administrator verifies that all nodes are powered on, network cables are connected, and the management switch is reachable. However, the ECS installation wizard reports that one node is not responding. What should the administrator check next?
Select an answer first
20application · medium
An administrator is preparing to deploy an ECS system and has received the hardware from Dell. Before starting the installation, the administrator wants to verify that all required components are present and that the system meets the prerequisites. Which action should the administrator take first?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to ECS-DEPLOY

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “ECS-DEPLOY” is a trademark of its owner, used for identification only.