Manage IP Addressing CCA-APPDS-TRAFFIC-MANAGEMENT Practice Questions (Page 2)

Questions 6–10

1. 6foundation · easy

   What is the primary purpose of an IP address in a network?

   • ATo uniquely identify a device on a network and enable routing of data to it
   • BTo provide a human-readable name for a website or service
   • CTo encrypt data transmitted between two devices on the internet
   • DTo physically identify a network interface card (NIC) on a local network
   Reveal Solution Discussion Select an answer first
2. 7expert · hard

   A Citrix ADC has a VIP 203.0.113.10 and a SNIP 203.0.113.11 on the same /24 subnet. The ADC is load balancing to backend servers on a different subnet. The administrator notices that the backend servers see the source IP of the traffic as the SNIP, but the client's real IP is required for logging. What should be configured to preserve the client IP?

   • AEnable Use Source IP (USIP) on the service or service group.
   • BAdd a MIP on the backend subnet to use as the source IP.
   • CChange the VIP's subnet mask to /16 to include the backend subnet.
   • DConfigure the VIP to use the SNIP as the source IP.
   Reveal Solution Discussion Select an answer first
4. 8application · medium

   A Citrix ADC appliance has a SNIP of 10.10.1.10/24 on interface 1/1. The backend web servers are on VLAN 20 with the subnet 10.10.2.0/24. The ADC needs to reach these servers to perform health checks and load balancing. The administrator has already created a VLAN 20 tagged interface. What additional configuration is required?

   • AConfigure a static route on the ADC pointing to the backend subnet via the existing SNIP.
   • BAssign a VIP from the 10.10.2.0/24 subnet for the load-balanced service.
   • CAdd a SNIP from the 10.10.2.0/24 subnet to the ADC.
   • DChange the existing SNIP subnet mask to /16 so it covers both subnets.
   Reveal Solution Discussion Select an answer first
5. 9foundation · easy

   What is the most common symptom of an IP address conflict on a network?

   • AThe devices are unable to communicate with each other but can still reach the internet
   • BIntermittent connectivity or complete loss of network access for one or both devices
   • CA permanent increase in network bandwidth usage
   • DAutomatic reconfiguration of both devices to new IP addresses
   Reveal Solution Discussion Select an answer first
6. 10expert · hard

   A Citrix ADC has a SNIP 172.16.1.10/24 on VLAN 10 and a SNIP 172.16.2.10/24 on VLAN 20. The ADC needs to load balance traffic to a service on 172.16.3.10/24. The administrator has configured a static route: 'add route 172.16.3.0 255.255.255.0 172.16.1.1'. However, health checks fail. What is the most likely issue?

   • AThe static route is not needed; the ADC should use the SNIP on VLAN 20 to reach the backend directly.
   • BThe SNIP on VLAN 20 is not bound to the service; bind the service to the SNIP.
   • CThe route should be added with a higher metric to ensure it is preferred over the default route.
   • DThe static route uses the wrong gateway; the gateway should be 172.16.2.1 if the route is intended to go through VLAN 20.
   Reveal Solution Discussion Select an answer first