What is the first step in the NX-OS password recovery process?

Interrupt the boot process to access the loader prompt

Enter the 'recover password' command in EXEC mode

Remove the startup configuration from the switch

Connect to the console port and press Ctrl-C

During password recovery on a Nexus switch, the technician has modified the configuration register to skip the startup configuration. After booting, they reset the password. What is the final step they must perform?

Erase the startup configuration to remove any old settings

Reboot the switch immediately to apply the new password

Copy the running configuration to a TFTP server

Restore the original configuration register value and save the configuration

What is the purpose of non-default VDCs in NX-OS?

To provide a backup operating system for the switch

To create multiple logical switches on a single physical switch

To allow the switch to run both NX-OS and IOS simultaneously

To increase the physical port density of the switch

Which Cisco hardware platforms run the NX-OS operating system?

Cisco ASA and Firepower appliances

Cisco Catalyst 2960 and 3560 switches

Cisco Nexus switches and MDS storage switches

CiscoCertified Field Technician (CCT)

Domain 5Objective 3

5.3 Describe the Process for Configuring Cisco NX-OS Software 800-150 Practice Questions (Page 3)

Part of the 5.0 Cisco Hardware Replacement domain, which accounts for 35% of the 800-150 exam. Cisco does not publish an official question count, but from its 120-minute exam (~50–80 total, ~18–28 in this domain), expect 5–7 from this objective — we provide 27 practice questions to prepare you well beyond it. (estimate)

27questions here

6free pages

8concepts

35%of the exam

Questions 11–15

11foundation · easy
What is the first step in the NX-OS password recovery process?
Select an answer first
12expert · hard
During password recovery on a Nexus switch, the technician has modified the configuration register to skip the startup configuration. After booting, they reset the password. What is the final step they must perform?
Select an answer first
13foundation · easy
What is the purpose of non-default VDCs in NX-OS?
Select an answer first
14foundation · easy
Which NX-OS CLI command mode is used to enter interface configuration mode?
Select an answer first
15foundation · easy
Which Cisco hardware platforms run the NX-OS operating system?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to 800-150

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Cisco. “800-150” is a trademark of its owner, used for identification only.