4.2 Implement Location Services 300-430 Practice Questions (Page 5)

Questions 21–25

1. 21foundation · easy

   What type of information does the Cisco wireless system use to determine the location of a non-Wi-Fi interferer after it has been detected by spectrum analysis?

   • AThe interferer's GPS coordinates, which are broadcast in its signal
   • BThe switch port to which the interferer is connected
   • CThe interferer's MAC address and IP address
   • DThe signal strength and angle of arrival measurements from multiple access points
   Reveal Solution Discussion Select an answer first
2. 22foundation · easy

   To enable tracking of active RFID tags on a Cisco wireless network, what must be configured on the wireless controller?

   • ASet the APs to operate in monitor mode only, disabling client service
   • BAssign each tag a static IP address in the same subnet as the controller
   • CEnable RFID tag tracking and specify the tag's manufacturer and model
   • DConfigure the tags to use the same SSID as the corporate network
   Reveal Solution Discussion Select an answer first
4. 23foundation · easy

   What is the primary role of the access points in the detection and location of a rogue access point?

   • AThey use their wired interface to trace the rogue AP's network connection
   • BThey listen for rogue AP beacons and report the received signal strength to the controller
   • CThey block the rogue AP's signal to prevent clients from associating
   • DThey send a deauthentication frame to the rogue AP to force it to reveal its location
   Reveal Solution Discussion Select an answer first
5. 24foundation · easy

   A developer wants to integrate real-time client location data from a Cisco wireless network into a custom application. Which interface is designed to provide this location data programmatically?

   • ASyslog messages from the access points
   • BNetFlow export from the controller
   • CSNMP MIB for wireless client location
   • DCisco Location API (part of Cisco DNA Spaces or CMX)
   Reveal Solution Discussion Select an answer first
6. 25expert · hard

   A hospital has a mix of Cisco 9130AXI and 9120AXI APs. The 9130AXI APs have BLE radios, but the 9120AXI APs do not. The hospital wants to track BLE tags for medical equipment with an accuracy of 2 meters. The 9120AXI APs are in areas where the 9130AXI APs cannot be installed due to ceiling constraints. What should the engineer do to achieve the required accuracy?

   • AInstall external BLE sensors in areas covered only by 9120AXI APs and use RSSI triangulation from those sensors
   • BUse ToF from the Wi-Fi radios to locate the BLE tags
   • CUse AoA from the 9130AXI APs only and accept lower accuracy in areas covered only by 9120AXI APs
   • DUse RSSI triangulation from all APs, including those without BLE radios, by using the Wi-Fi radio to hear the BLE tags
   Reveal Solution Discussion Select an answer first