3.1 Interpret the Components of Routing Table 200-301 Practice Questions (Page 3)

Questions 11–15

1. 11application · medium

   A router has a static route to 192.168.100.0/24 with an administrative distance of 1, and an OSPF route to the same network with an administrative distance of 110. Which route will be used to forward traffic to 192.168.100.5?

   • ABoth routes, because they have different administrative distances and can be load-balanced.
   • BThe static route, because it has a lower administrative distance.
   • CThe OSPF route, because it has a lower metric.
   • DThe OSPF route, because dynamic routes are more reliable.
   Reveal Solution Discussion Select an answer first
2. 12application · medium

   A router running OSPF has two routes to 10.20.30.0/24. Route A has a metric of 30 and was learned from a neighbor at 192.168.1.1. Route B has a metric of 45 and was learned from a neighbor at 192.168.2.1. Which route will be installed in the routing table?

   • ABoth routes will be installed for load balancing
   • BRoute A, because it has the lower metric
   • CThe route with the lower administrative distance
   • DRoute B, because it has the higher metric
   Reveal Solution Discussion Select an answer first
4. 13application · medium

   A router has a route entry: O 10.0.0.0/8 [110/20] via 192.168.1.1. Which of the following IP addresses will this route match?

   • A10.0.0.0
   • B11.1.2.3
   • C10.1.2.3
   • D192.168.1.1
   Reveal Solution Discussion Select an answer first
5. 14expert · hard

   A network administrator is reviewing the routing table of a router and sees the following entries: 'O 10.10.0.0/16 [110/50] via 192.168.1.1', 'D 10.10.0.0/16 [90/30720] via 192.168.2.1', and 'S 10.10.0.0/16 [1/0] via 192.168.3.1'. Which route will be installed in the routing table?

   • AThe static route, because it has the lowest administrative distance.
   • BThe OSPF route, because it has the lowest metric.
   • CThe EIGRP route, because it has the lowest metric among dynamic routes.
   • DAll three routes, because they are from different protocols and can be load-balanced.
   Reveal Solution Discussion Select an answer first
6. 15expert · hard

   A network engineer is troubleshooting a routing issue. The routing table shows two OSPF routes to 10.0.0.0/16: one with metric 30 via 192.168.1.1, and one with metric 30 via 192.168.2.1. Both routes have the same administrative distance. What will the router do with traffic to 10.0.1.1?

   • AUse only the route via 192.168.2.1 because it has a higher IP address.
   • BDrop the traffic because two equal routes cause a routing loop.
   • CUse only the route via 192.168.1.1 because it was learned first.
   • DLoad-balance traffic across both next hops.
   Reveal Solution Discussion Select an answer first