4.8 Configure Network Devices for Remote Access Using SSH 200-301 Practice Questions (Page 2)

Questions 6–10

1. 6application · easy

   A network administrator is on a Cisco router and needs to SSH to a remote device with IP address 10.1.1.1 using username 'netadmin'. The administrator also wants to verify the SSH connection after it is established. Which command initiates the SSH session?

   • Atelnet 10.1.1.1
   • Bssh -l netadmin 10.1.1.1
   • Cssh 10.1.1.1 -u netadmin
   • Dconnect 10.1.1.1 netadmin
   Reveal Solution Discussion Select an answer first
2. 7foundation · easy

   Which set of commands is required to enable SSH server functionality on a Cisco IOS device?

   • Aip domain-name example.com, crypto key generate rsa, enable secret cisco, line vty 0 4
   • Bcrypto key generate rsa, ip ssh version 2, line vty 0 4, transport input ssh
   • Chostname R1, ip domain-name example.com, crypto key generate rsa, ip ssh version 2
   • Dhostname R1, ip ssh port 22, transport input ssh, login local
   Reveal Solution Discussion Select an answer first
4. 8application · easy

   A network engineer is configuring SSH on a Cisco router. The engineer wants to use local authentication with a username of 'admin' and password 'Cisco123'. Which configuration is required on the VTY lines?

   • Alogin local
   • Bpassword Cisco123
   • Cexec-timeout 5
   • Dtransport input ssh
   Reveal Solution Discussion Select an answer first
5. 9application · medium

   A network engineer is configuring a Cisco IOS switch to support SSH for remote management. The switch currently has a default hostname and no domain name configured. The engineer has already created a local user with a password and enabled the VTY lines to use login local. Which additional configuration is required before SSH can be enabled?

   • AConfigure a hostname and domain name, then generate an RSA key pair.
   • BCreate an access list to permit SSH traffic to the switch.
   • CConfigure a default gateway and enable IP routing.
   • DSet the transport input to telnet on the VTY lines.
   Reveal Solution Discussion Select an answer first
6. 10application · medium

   A network engineer is configuring SSH on a new router. The engineer has set the hostname to 'R1' and the domain name to 'example.com'. What is the next required step to enable SSH?

   • ACreate a local user account with a password.
   • BConfigure the VTY lines with transport input ssh.
   • CSet the SSH version to 2 using ip ssh version 2.
   • DGenerate an RSA key pair using crypto key generate rsa.
   Reveal Solution Discussion Select an answer first