Examers.io
ExamsOrganizationsHow it worksPricingHelp & FAQ
Cisco logo

CiscoCertified Network Associate (CCNA)

Domain 2Objective 1

2.1 Configure and Verify VLANs (normal Range) Spanning Multiple Switches 200-301 Practice Questions (Page 3)

Part of the Network Access domain, which accounts for 20% of the 200-301 exam. Cisco does not publish an official question count, but from its 120-minute exam (~50–80 total, ~10–16 in this domain), expect 1–2 from this objective — we provide 32 practice questions to prepare you well beyond it. (estimate)

32questions here
7free pages
8concepts
20%of the exam

Questions 11–15

  1. 11application · medium

    A switch port is configured as an access port in VLAN 10. An IP phone is connected to the port, and the phone's PC port is connected to a workstation. The phone is configured to use VLAN 20 for voice. The workstation cannot access the network. The switch port configuration is: 'switchport mode access', 'switchport access vlan 10', 'switchport voice vlan 20'. Which command would verify that the workstation's traffic is being placed in VLAN 10?

    Select an answer first
  2. 12foundation · easy

    What is the effect of the 'switchport access vlan 20' command on a switch port that is currently in default mode?

    Select an answer first
  3. 13application · medium

    A company is deploying IP phones. Each desk has a phone and a PC. The PC must be in VLAN 50, and the phone in VLAN 150. The administrator configures the access port with 'switchport access vlan 50' and 'switchport voice vlan 150'. What must also be configured for the phone to work correctly?

    Select an answer first
  4. 14application · medium

    Two switches are connected with a trunk link. VLAN 50 is configured on both switches. A host connected to switch A in VLAN 50 cannot ping a host connected to switch B in VLAN 50. The trunk link is up and 'show interfaces trunk' on both switches shows VLAN 50 in the allowed list. What is the most likely cause?

    Select an answer first
  5. 15foundation · easy

    Which command is used on a router subinterface to enable 802.1Q tagging for VLAN 10?

    Select an answer first
Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Cisco. “200-301” is a trademark of its owner, used for identification only.