3.3 Configure and Verify IPv4 and IPv6 Static Routing 200-301 Practice Questions (Page 2)

Questions 6–10

1. 6expert · medium

   A router has two default routes configured: ip route 0.0.0.0 0.0.0.0 192.168.1.1 ip route 0.0.0.0 0.0.0.0 192.168.2.1 200 The primary link to 192.168.1.1 goes down, but the router continues to use the primary route. What is the most likely cause?

   • AThe floating route was configured with the wrong next-hop address.
   • BThe router does not support floating static routes.
   • CThe floating route has an administrative distance that is too high.
   • DThe primary route is still in the routing table because the interface did not go down.
   Reveal Solution Discussion Select an answer first
2. 7application · medium

   A network engineer is configuring a dual-stack router. The router must forward IPv6 traffic to the internet through an upstream router with link-local address FE80::2 on interface GigabitEthernet0/1. Which command correctly configures an IPv6 default route?

   • Aipv6 route 0.0.0.0/0 GigabitEthernet0/1 FE80::2
   • Bipv6 route ::/0 GigabitEthernet0/1 FE80::2
   • Cipv6 route ::/0 FE80::2
   • Dip route ::/0 GigabitEthernet0/1 FE80::2
   Reveal Solution Discussion Select an answer first
4. 8expert · hard

   A router has a primary static route to 10.0.0.0/8 via 192.168.1.1 and a floating static route via 192.168.2.1 with AD 200. The primary route is removed from the routing table, but the floating route does not appear. Which is the most likely cause?

   • AThe router is running OSPF, which overrides static routes.
   • BThe floating route was configured with the wrong destination mask.
   • CThe administrative distance of the floating route is too low.
   • DThe next-hop 192.168.2.1 is not reachable via any directly connected or static route.
   Reveal Solution Discussion Select an answer first
5. 9expert · easy

   A router has a static host route for 192.168.1.10/32 via 10.0.0.1 and a static network route for 192.168.1.0/24 via 10.0.0.2. A packet destined for 192.168.1.10 arrives. Which route will the router use?

   • AThe network route via 10.0.0.2
   • BBoth routes will be used for load balancing.
   • CThe host route via 10.0.0.1
   • DThe router will drop the packet because of conflicting routes.
   Reveal Solution Discussion Select an answer first
6. 10expert · medium

   A router has the following routes configured: ip route 0.0.0.0 0.0.0.0 192.168.1.1 ip route 10.0.0.0 255.0.0.0 192.168.2.1 ip route 10.1.0.0 255.255.0.0 192.168.3.1 ip route 10.1.1.0 255.255.255.0 192.168.4.1 ip route 10.1.1.1 255.255.255.255 192.168.5.1 A packet is destined for 10.1.1.1. Which next-hop will the router use?

   • A192.168.4.1
   • B192.168.1.1
   • C192.168.5.1
   • D192.168.3.1
   Reveal Solution Discussion Select an answer first