NSX Architecture and Components VCP-NV Practice Questions (Page 3)

Questions 11–15

1. 11application · medium

   An administrator needs to enable IP discovery and MAC learning on a specific NSX-T segment to support a legacy application that uses non-IP protocols. The administrator wants to apply these settings only to this segment, not to all segments in the transport zone. What should the administrator do?

   • AEnable IP discovery and MAC learning on the NSX Manager cluster.
   • BModify the transport zone settings to enable IP discovery and MAC learning.
   • CCreate a new segment profile and apply it to the specific segment.
   • DCreate a new logical switch and move the VMs to it.
   Reveal Solution Discussion Select an answer first
2. 12application · medium

   A network administrator is troubleshooting a performance issue on an NSX-T overlay network. VMs on the same segment are experiencing high latency. The administrator suspects that the Geneve encapsulation is causing overhead. Which component is responsible for the encapsulation and decapsulation of Geneve packets?

   • AThe NSX Manager cluster
   • BThe transport node's N-VDS
   • CThe vCenter Server
   • DThe NSX Edge node
   Reveal Solution Discussion Select an answer first
4. 13foundation · easy

   In the NSX UI, which section would an administrator navigate to in order to create and manage logical switches?

   • ANetworking > Load Balancing
   • BSecurity > Firewall
   • CNetworking > Segments
   • DSystem > Fabric
   Reveal Solution Discussion Select an answer first
5. 14foundation · easy

   Which component is a part of the NSX management cluster?

   • AESXi transport nodes
   • BNSX Edge nodes
   • CGeneve tunnels
   • DNSX Manager nodes
   Reveal Solution Discussion Select an answer first
6. 15application · medium

   A company is deploying NSX-T Data Center to provide multi-tenant networking for two business units that must remain isolated from each other. The network team plans to create a single transport zone and add all ESXi hosts to it. They want to use Geneve encapsulation for the overlay. Which two configuration elements must be created to ensure the two business units can communicate internally but not with each other?

   • ACreate two separate segments and place each business unit's VMs on its own segment, then apply a distributed firewall rule to block traffic between the segments.
   • BCreate two logical switches and connect them with a router, then rely on the router's access control lists to block traffic.
   • CCreate two separate transport zones and place each business unit's hosts in its own zone, then configure routing between the zones.
   • DCreate one segment and use VLAN tagging to separate the business units at Layer 2.
   Reveal Solution Discussion Select an answer first