Which NSX feature allows you to verify the status of an IPsec VPN session?

The vSphere client's network tab

The VPN session monitoring page in the NSX UI

The NSX Manager system logs only

An NSX administrator has a NAT rule that is causing unexpected behavior. The rule is enabled and has a high priority. The administrator wants to temporarily stop the rule from being applied without deleting it, so that other rules can be tested. What should the administrator do?

Change the rule's priority to the lowest value

When troubleshooting a NAT issue in NSX, which of the following is a common first step?

Change the gateway's routing protocol

Verify that the NAT rule is enabled and correctly configured

Delete and recreate the NAT rule

Reboot the Tier-0 or Tier-1 gateway

An administrator configured an IPsec VPN between two NSX sites. The VPN tunnel is down, and the administrator needs to troubleshoot the issue. The administrator checks the VPN session status and sees that the tunnel is not established. What should the administrator check next?

Check if the firewall rules allow traffic through the tunnel

Verify that the local and peer endpoints are reachable

Verify that the encryption algorithm is correct

Check if the VPN session is using the correct authentication method

VMwareCertified Professional – Network Virtualization (VCP-NV)

Domain 2Objective 3

Network Services VCP-NV Practice Questions (Page 4)

Part of the Install, Configure, Administrate the VMware Solution domain, which makes up ~44% of our current practice bank.

26questions here

6free pages

8concepts

Questions 16–20

16application · medium
An administrator is configuring an L2 VPN on an NSX Tier-0 gateway. The VPN must extend a Layer 2 segment from the primary site to a secondary site. The administrator needs to specify which segment to extend. Which setting should be configured?
Select an answer first
17foundation · easy
Which NSX feature allows you to verify the status of an IPsec VPN session?
Select an answer first
18application · medium
An NSX administrator has a NAT rule that is causing unexpected behavior. The rule is enabled and has a high priority. The administrator wants to temporarily stop the rule from being applied without deleting it, so that other rules can be tested. What should the administrator do?
Select an answer first
19foundation · easy
When troubleshooting a NAT issue in NSX, which of the following is a common first step?
Select an answer first
20expert · medium
An administrator configured an IPsec VPN between two NSX sites. The VPN tunnel is down, and the administrator needs to troubleshoot the issue. The administrator checks the VPN session status and sees that the tunnel is not established. What should the administrator check next?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to VCP-NV

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by VMware. “VCP-NV” is a trademark of its owner, used for identification only.