Zero-Touch Provisioning (ZTP) JN0-683 Practice Questions (Page 2)

Questions 6–10

1. 6foundation · easy

   After a Juniper device obtains its IP address and the provisioning server location via DHCP during ZTP, what is the next step in the process?

   • AThe device downloads the configuration file from the provisioning server and applies it
   • BThe device waits for an administrator to approve the configuration before proceeding
   • CThe device reboots automatically to apply the new IP address
   • DThe device sends a syslog message to the provisioning server to confirm connectivity
   Reveal Solution Discussion Select an answer first
2. 7foundation · easy

   Which DHCP option is commonly used to provide the configuration file name to a Juniper device during ZTP?

   • AOption 150 (TFTP server address)
   • BOption 67 (boot file name)
   • COption 66 (TFTP server name)
   • DOption 3 (router)
   Reveal Solution Discussion Select an answer first
4. 8application · medium

   A network engineer is deploying a new Juniper QFX5110 switch in a data center. The switch boots with factory defaults and sends DHCP requests on the management interface. The DHCP server is configured to provide the IP address, the TFTP server address, and the configuration file name. The engineer wants the switch to automatically load a configuration file from the TFTP server. Which DHCP option must be configured on the DHCP server to specify the configuration file name?

   • AOption 60 (vendor class identifier)
   • BOption 66 (TFTP server name)
   • COption 150 (TFTP server address)
   • DOption 67 (bootfile name)
   Reveal Solution Discussion Select an answer first
5. 9foundation · easy

   What is the primary purpose of Zero-Touch Provisioning (ZTP) in a Juniper data center network?

   • ATo enable secure remote access to network devices for administrative purposes
   • BTo automate the initial configuration of new devices without requiring an administrator to manually configure each device
   • CTo provide real-time monitoring and alerting for network devices after they are deployed
   • DTo automatically optimize network traffic flow and load balancing across data center links
   Reveal Solution Discussion Select an answer first
6. 10application · medium

   A new Juniper QFX5110 switch is being deployed in a data center. The switch boots, obtains an IP address via DHCP, but fails to download the configuration file from the TFTP server. The DHCP server is configured with option 150 pointing to the TFTP server, and option 67 is set to 'config.txt'. The TFTP server is reachable from the management network. What is the most likely cause of the failure?

   • AThe TFTP server does not have the file 'config.txt' in its root directory
   • BThe DHCP server is not providing the default gateway
   • CThe TFTP server is using a different port than the default
   • DThe switch is not configured with the correct management IP address
   Reveal Solution Discussion Select an answer first