Which Junos configuration statement applies a routing policy to OSPF for controlling route advertisement?

set protocols ospf import policy-name

set protocols ospf export policy-name

set policy-options policy-statement policy-name term 1 from protocol ospf

set routing-options ospf export policy-name

Which operational command would you use to verify that an OSPF route for 10.10.10.0/24 is present in the routing table?

show ospf database 10.10.10.0/24

show ospf neighbor 10.10.10.0/24

What is the primary benefit of configuring route summarization at an OSPF area boundary?

It allows OSPF to run over non-IP networks.

It eliminates the need for OSPF authentication.

It increases the speed of OSPF neighbor formation.

It reduces the size of the routing table and the number of LSAs propagated.

Which statement correctly describes the default OSPF behavior on a Junos device when you configure an interface under an OSPF area?

The interface is passive by default and will not send or receive OSPF packets.

The interface will only send hello packets if it has a loopback address configured.

The interface becomes active in OSPF and starts sending hello packets on that segment.

The interface will only participate in OSPF if it is a broadcast type.

Juniper NetworksCertified Professional, Service Provider Routing and Switching (JNCIP-SP)

Domain 1Objective 8

Configure or Monitor Single-Area or Multi-Area OSPF with Routing Policy JN0-664 Practice Questions (Page 2)

Part of the OSPF domain, which makes up ~19% of our current practice bank. Juniper Networks does not publish an official question count, but from its 90-minute exam (~35–60 total, ~7–11 in this domain), expect 1–1 from this objective — we provide 20 practice questions to prepare you well beyond it. (estimate)

20questions here

4free pages

10concepts

Questions 6–10

6foundation · easy
Which Junos configuration statement applies a routing policy to OSPF for controlling route advertisement?
Select an answer first
7foundation · easy
Which operational command would you use to verify that an OSPF route for 10.10.10.0/24 is present in the routing table?
Select an answer first
8foundation · easy
What is the primary benefit of configuring route summarization at an OSPF area boundary?
Select an answer first
9foundation · easy
Which statement correctly describes the default OSPF behavior on a Junos device when you configure an interface under an OSPF area?
Select an answer first
10foundation · easy
Which OSPF area type is used when you need to import external routes into a stub-like area?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to JN0-664

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Juniper Networks. “JN0-664” is a trademark of its owner, used for identification only.