Services Redundancy Group (SRG) JN0-637 Practice Questions (Page 1)

Questions 1–5

1. 1foundation · easy

   Which command would you use to view the status of a services redundancy group (SRG) on an SRX Series device?

   • Ashow chassis cluster status
   • Bshow redundancy-group status
   • Cshow services redundancy-group status
   • Dshow high-availability status
   Reveal Solution Discussion Select an answer first
2. 2foundation · easy

   How can services redundancy groups (SRGs) and chassis clustering be used together in a multinode HA deployment?

   • ASRGs are used to synchronize configuration between chassis cluster nodes
   • BSRGs replace chassis clustering entirely, so they cannot be used together
   • CChassis clustering is used to manage SRGs, but they operate independently
   • DSRGs can be configured within a chassis cluster to provide redundancy for specific services across the cluster nodes
   Reveal Solution Discussion Select an answer first
4. 3expert · hard

   A company is deploying a pair of SRX devices in a multinode HA configuration. They need to provide redundancy for both the firewall service and the IPS service. The firewall service must be active on node 1, and the IPS service must be active on node 2, to distribute the load. They also need to ensure that if one node fails, the other node takes over both services. Which configuration approach meets these requirements?

   • AConfigure two SRGs: one for the firewall service with node 1 as primary, and one for the IPS service with node 2 as primary. Enable session synchronization for both SRGs.
   • BUse chassis clustering with active/active mode, and configure SRG for both services on the same node.
   • CConfigure a single SRG that includes both firewall and IPS services, with node 1 as primary for both.
   • DConfigure one SRG for firewall and use a routing protocol for IPS redundancy.
   Reveal Solution Discussion Select an answer first
5. 4foundation · easy

   What is the primary purpose of a services redundancy group (SRG) in a multinode high availability deployment on SRX Series devices?

   • ATo enable load balancing of traffic across multiple nodes in an active/active configuration
   • BTo provide stateful failover of security services between two chassis in an active/backup configuration
   • CTo synchronize routing tables between nodes to ensure consistent forwarding decisions
   • DTo provide a single management interface for all nodes in a cluster
   Reveal Solution Discussion Select an answer first
6. 5foundation · easy

   What state information is synchronized between nodes in a services redundancy group (SRG) to maintain session consistency?

   • ARouting table entries and forwarding information base
   • BConfiguration files and system logs
   • CUser authentication and authorization data
   • DSession table entries, including NAT translations and security associations
   Reveal Solution Discussion Select an answer first