Interchassis Link JN0-637 Practice Questions (Page 1)

Questions 1–5

1. 1foundation · easy

   Which command is used to monitor the status of the interchassis link (ICL) on a Juniper multinode HA device?

   • Ashow interfaces terse
   • Bshow chassis cluster interfaces
   • Cshow configuration interfaces
   • Dshow log messages
   Reveal Solution Discussion Select an answer first
2. 2foundation · easy

   When configuring the interchassis link (ICL) on a Juniper device, what is the typical encapsulation type used?

   • AHDLC
   • BPPP
   • CEthernet
   • DFrame Relay
   Reveal Solution Discussion Select an answer first
4. 3foundation · easy

   Which of the following must be specified when configuring the interchassis link (ICL) on a Juniper multinode HA device?

   • AThe interface and the routing protocol to run over it
   • BThe interface and the VLAN ID for the link
   • CThe interface and the MTU size
   • DThe interface, IP address, and encapsulation type
   Reveal Solution Discussion Select an answer first
5. 4foundation · easy

   During a failover in a Juniper multinode HA pair, how does the ICL contribute to traffic forwarding?

   • AIt provides a backup path for internet traffic if the primary WAN link fails
   • BIt allows the surviving node to take over the failed node's traffic by forwarding it to the appropriate interfaces
   • CIt reroutes traffic to the management network for inspection
   • DIt immediately shuts down all traffic to prevent loops
   Reveal Solution Discussion Select an answer first
6. 5foundation · easy

   Which redundancy feature is commonly used for the interchassis link (ICL) to ensure high availability?

   • ASpanning Tree Protocol (STP)
   • BVirtual Router Redundancy Protocol (VRRP)
   • CEqual-Cost Multipath (ECMP)
   • DLink aggregation (e.g., LACP)
   Reveal Solution Discussion Select an answer first